Related papers: Double-absorber thin-film solar cell with 34% effi…
Epitaxially-grown quantum well and quantum dot solar cells suffer from weak light absorption, strongly limiting their performance. Light trapping based on optical resonances is particularly relevant for such devices to increase light…
Tandem solar cells can better harness the energy of the solar spectrum. Chalcopyrite solar cells have drawn attention, being the only highly efficient devices with bandgap around 1.0 eV, suitable for bottom cells. In the quest for better…
Following the recent success of monolithically integrated Perovskite/Si tandem solar cells, great interest has been raised in searching for alternative wide bandgap top-cell materials with prospects of a fully earth-abundant, stable and…
Low cost, highly efficient, and stable solar cells demand low temperature processing, less stringent criteria on materials, and possibility of dynamic recovery from long term degradation: a combination of features unachievable from the…
Sulfide chalcopyrite Cu(In,Ga)S2 (CIGS) is a wide bandgap semiconductor suitable for the top cell of a tandem solar device. Here we demonstrate significant improvements in absorber quality by alloying with Ag to form (Ag,Cu)(In,Ga)S2…
Organic-inorganic halide perovskite materials have emerged as attractive alternatives to conventional solar cell building blocks. Their high light absorption coefficients and long diffusion lengths suggest high power conversion efficiencies…
We demonstrate a non-destructive approach to provide structural properties on the grain level for the absorber layer of kesterite solar cells. Kesterite solar cells are notoriously difficult to characterize structurally due to the…
Synthetic perovskites with photovoltaic properties open a new era in solar photovoltaics. Due to high optical absorption perovskite-based thin-film solar cells are usually considered as fully absorbing solar radiation on condition of ideal…
Since thin-film silicon solar cells have limited optical absorption, we explore the effect of a nanostructured back reflector to recycle the unabsorbed light. As a back reflector we investigate a 3D photonic band gap crystal made from…
It has gradually been recognized that incoming sunlight can be trapped within a high refractive index semiconductor, n~3.5, owing to the narrow 16degree escape cone. The solar light inside a semiconductor is 4n^2 times brighter than…
The photosensitivity of silicon is inherently very low in the visible electromagnetic spectrum, and it drops rapidly beyond 800 nm in near-infrared wavelengths. Herein, we have experimentally demonstrated a technique utilizing…
Solar arrays are the primary energy source of the satellite. In this paper, a metamaterial absorber for solar arrays with simultaneous high optical transparency and broadband microwave absorption is presented. By tailoring the reflection…
Ultrathin planar absorbing layers, including semiconductor and metal films, and 2D materials, are promising building blocks for solar energy harvesting devices but poor light absorption has been a critical issue. Although interference in…
We report the development of broadband solar absorber coatings based on titanium suboxide composite thin films on aluminium substrates. The films are fabricated via scalable DC magnetron sputtering using a Ti target, followed by…
Sulfide Kesterite Cu2ZnSnS4 (CZTS), a nontoxic and low-cost photovoltaic material, has always being facing severe charge recombination and poor carrier transport, resulting in the cell efficiency record stagnating around 11% for years.…
The absorption of thin hydrogenated amorphous silicon layers can be efficiently enhanced through a controlled periodic patterning. Light is trapped through coupling with photonic Bloch modes of the periodic structures, which act as an…
Improving the conversion efficiency of solar energy to electricity is most important to mankind. For single-junction photovoltaic solar-cells, the Shockley-Queisser thermodynamic efficiency limit is extensively due to the heat dissipation,…
Atomically thin layered materials such as graphene and transition-metal dichalcogenides exhibit great potential as active materials in optoelectronic devices because of their high carrier-transporting properties and strong light-matter…
Maximizing the power conversion efficiency of solar cells plays a crucial role in upscaling solar energy production. Combining two or more solar cells with different bandgaps into a multi-junction tandem solar cells lowers thermalization…
The purpose of this work is to look for a practical structure for application of quantum dots (QD) in solar cells in order to enhance sub-band gap photon absorption. We focuse on a stack of strain-compensated GaSb/GaAs type-II QDs. We…