Related papers: Current density distribution in resistive fault cu…
The maximum current that can be transported across a vacuum diode is limited by forces arising due to space charge. In a planar diode configuration, the space charge limited (SCL) current density from a planar emitting patch is given by the…
In the last decades, the applications of power inverter increased rapidly. As a result, in spite of rectifier, an inverter with a high-power electronic oscillator has capability to convert direct current (DC) into alternating current (AC)…
The Rayleigh-Taylor (RT) instability is ubiquitously observed, yet has traditionally been studied using ideal fluid models. Collisionality can vary strongly across the fluid interface, and previous work demonstrates the necessity of kinetic…
The local nonequilibrium quasiparticle distribution function in a normal-metal wire depends on the applied voltage over the wire and the type and strength of different scattering mechanisms. We show that in a setup with superconducting…
Robotic control systems are increasingly relying on distributed feedback controllers to tackle complex sensing and decision problems such as those found in highly articulated human-centered robots. These demands come at the cost of a…
We study the stability of two-fluid flow through a plane channel at Reynolds numbers of a hundred to a thousand in the linear and nonlinear regimes. The two fluids have the same density but different viscosities. The fluids, when miscible,…
For many technological applications of superconductors the performance of a material is determined by the highest current it can carry losslessly - the critical current. In turn, the critical current can be controlled by adding…
We calculate the degree of flux pinning by defects in model high-temperature superconductors (HTSC's). The HTSC is modeled as a three-dimensional network of resistively-shunted Josephson junctions in an external magnetic field,…
A protection method in active distribution networks is proposed in this paper. In active distribution systems, fault currents flow in multiple directions and presents a varying range of value, which poses a great challenge of maintaining…
The distribution of thermally excited vortex loops near a superfluid phase transition is calculated from a renormalized theory. The number density of loops with a given perimeter is found to change from exponential decay with increasing…
The superconducting-insulator transition is simulated in disordered networks of Josephson junctions with thermally activated Arrhenius-like resistive shunt. By solving the conductance matrix of the network, the transition is reproduced in…
We study current-voltage (V-I) characteristics of short superconducting nanowires of length ~ 100 nm exposed to microwave radiation of frequencies between 100 MHz and 15 GHz. The radiation causes a decrease of the average switching current…
There are several ways to turn a superconductor into a normal conductor: increase the temperature, apply a high magnetic field, or run a large current. High-T$_c$ cuprate superconductors are unusual in the sense that experiments suggest…
A simple model for simulating the current dynamics and the magnetic properties of superconductors is presented. Short simulation times are achieved by solving the differential form of Maxwell's equations inside the sample, whereas…
In this work, a Josephson junction consisting of two superconducting layers sandwiching an insulating layer is explored, which is subject to the effects of thermal fluctuations. The precise expressions for the evolution of Josephson phase…
We have obtained the universal conductance distribution of two-dimensional disordered systems in the strongly localized limit. This distribution is directly related to the Tracy-Widom distribution, which has recently appeared in many…
In this paper I discuss analytic and numerical calculations of the magnetic-field and sheet-current distributions in superconducting strips of width 2a and arbitrary thickness 2b at the center when the cross section is an ellipse, a…
The properties of one-dimensional superconductors are strongly influenced by topological fluctuations of the order parameter, known as phase slips, which cause the decay of persistent current in superconducting rings and the appearance of…
A circuit-simulation-based method is used to determine the thermally-induced bit error rate of superconducting logic circuits. Simulations are used to evaluate the multidimensional Gaussian integral across noise current sources attached to…
We theoretically investigate the supercurrent flow in a Josephson junction consisting of two spin-split superconductors combined by a normal metal weak link. The normal metal may be driven out of equilibrium, thus modifying the electron and…