Related papers: Current density distribution in resistive fault cu…
High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent…
Deploying synchronous condensers (SynCons) near grid-following renewable energy sources (GFLRs) is an effective and increasingly adopted strategy for grid support. However, the potential transient instability risks in such configurations…
A superconducting fault current limiter of the transformer type (inductive FCL) based on magnetic coupling between a superconducting element and a protected circuit has been investigated by many authors for various parameters and…
We show that in disordered superconductors, at sufficiently low frequencies $\omega$, the coupling of TLS to external ac electric fields increases dramatically in the presence of a dc supercurrent. This giant enhancement manifests in all ac…
A two-dimensional model is introduced that describes current sharing between the superconducting and normal metal layers in configuration typical of YBCO-coated conductors. The model is used to compare the effectiveness of surround…
Grid forming control applied to power converters that interface storage or renewable generation to the power grid, has been identified as a potential solution to facilitate a substantial share of converter-based renewable generation in the…
We present the results of numerical analysis of a model of normal zone propagation in coated conductors. The main emphasis is on the effects of increased contact resistance between the superconducting film and the stabilizer on the speed of…
Experiments have shown that flow in compliant microchannels can become unstable at a much lower Reynolds number than the corresponding flow in a rigid conduit. Therefore, it has been suggested that the wall's elastic compliance can be…
We present a scattering description of transport in several normal-superconductor structures. We show that the related requirements of self-consistency and current conservation introduce qualitative changes in the transport behavior when…
We study the current flow paths between two edges in a random resistor network on a $L\times L$ square lattice. Each resistor has resistance $e^{ax}$, where $x$ is a uniformly-distributed random variable and $a$ controls the broadness of…
The dynamics of the superconducting phase difference across a Josephson junction can be described within the resistively and capacitively shunted Josephson junction (RCSJ) model. Microscopic derivations of this model traditionally rely on…
With increased share of Static Frequency Converters (SFCs) in 16$\frac{2}{3}$ Hz railway grids concerns about stability have increased. Stability studies for such low-frequency railway grids are few, and models that describe SFC dynamics…
The effect of morphologic factors on magnetic flux dynamics and critical currents in percolative superconducting structures is considered. The superconductor contains the fractal clusters of a normal phase, which act as pinning centers. The…
We analyze the dynamical evolution of the current and the charge density in a superlattice for fixed external dc voltage in the regime of self-sustained current oscillations, using a microscopic sequential tunneling model. Fronts of…
We study the multifractal properties of the current distribution of the three-dimensional random resistor network at the percolation threshold. For lattices ranging in size from $8^3$ to $80^3$ we measure the second, fourth and sixth…
We calculate suppression of inter- and intralayer superconducting currents due to equilibrium phase fluctuations and find that, in contrast to a recent prediction, the effect of thermal fluctuations cannot account for linear temperature…
It has been suggested that Rapid Single Flux Quantum (RSFQ) devices could be used as the classical interface of superconducting qubit systems. One problem is that the interface acts as a dissipative environment for a qubit. Recently ways to…
Loops undergoing thermal fluctuations are prevalent in nature. Ring-like or cross-linked polymers, cyclic macromolecules, and protein-mediated DNA loops all belong to this category. Stability of these molecules are generally described in…
Current-mode control is one of the most popular controller strategies for power converters. With the advent of wide bandgap devices including GaN and SiC, higher switching frequencies have become more viable at higher power because of lower…
Conductions fluctuations (CF) are studied in single layer graphene devices with superconducting source and drain contacts made from aluminium. The CF are found to be enhanced by superconductivity by a factor of 1.4 to 2. This (near)…