Related papers: Plate motion in sheared granular fault system
This study examines the flow of dense granular materials under external shear stress and pressure using discrete element method simulations. In this method, the material is allowed to strain along all periodic directions and adapt its solid…
We report on experimentally observed shear stress fluctuations in both granular solid and fluid states, showing that they are non-Gaussian at low shear rates, reflecting the predominance of correlated structures (force chains) in the…
Shear transformations (i.e., localised rearrangements of particles resulting in the shear deformation of a small region of the sample) are the building blocks of mesoscale models for the flow of disordered solids. In order to compute the…
Strongly confined colloidal dispersions under shear can exhibit a variety of dynamical phenomena, including depinning transitions and complex structural changes. Here, we investigate the behaviour of such systems under pure oscillatory…
We consider a Navier-Stokes fluid-plate interaction (FSI) system which describes the evolutions of the fluid contained within a 3D cavity, as it interacts with a deformable elastic membrane on the ``free" upper boundary of the cavity. These…
This paper presents a class of turbulence models written in terms of fractional partial differential equations (FPDEs) with stochastic loads. Every solution of these FPDE models is an incompressible velocity field and the distribution of…
Despite extensive studies on either smooth granular-fluid flow or the solid-like deformation at the slow limit, the change between these two extremes remains largely unexplored. By systematically investigating the fluctuations of tightly…
Discrete particle simulation, a combined approach of computational fluid dynamics and discrete methods such as DEM (Discrete Element Method), DSMC (Direct Simulation Monte Carlo), SPH (Smoothed Particle Hydrodynamics), PIC…
The development of rate- and state-dependent friction laws offered important insights into the key physical mechanisms of the frictional behaviour of fault gouges and their seismic cycle. However, past approaches were specifically tailored…
This paper focuses on the isogeometric vibration analysis of curvilinearly stiffened composite panels. The stiffness matrices and the mass matrices are derived using the first-order shear deformation theory (FSDT). The present method models…
Spreading of fine (D50 <=20um) powders into thin layers typically requires a mechanism such as a roller to overcome the cohesive forces between particles. Roller-based spreading requires careful optimization and can result in low density…
Here we theoretically and computationally study the frequency dependence of phase speed and attenuation for marine sediments from the perspective of granular mechanics. We leverage recent theoretical insights from the granular physics…
We propose a simple continuum model to interpret the shearing motion of dense, dry and cohesion-less granular media. Compressibility, dilatancy and Coulomb-like friction are the three basic ingredients. The granular stress is split into a…
The behavior of granular column collapses is associated with the dynamics of geohazards, such as debris flows, landslides, and pyroclastic flows, yet its underlying physics is still not well understood. In this paper, we explore granular…
Faceted shapes, such as polyhedra, are commonly found in systems of nanoscale, colloidal, and granular particles. Many interesting physical phenomena, like crystal nucleation and growth, vacancy motion, and glassy dynamics are challenging…
Molecular dynamics simulations of a short-chain polymer melt between two brush-covered surfaces under shear have been performed. The end-grafted polymers which constitute the brush have the same chemical properties as the free chains in the…
We propose a theory of shear flow in dense granular materials. A key ingredient of the theory is an effective temperature that determines how the material responds to external driving forces such as shear stresses and vibrations. We show…
Simulation of fracturing processes in porous rocks can be divided into two main branches: (i) modeling the rock as a continuum which is enhanced with special features to account for fractures, or (ii) modeling the rock by a discrete (or…
``Shear softening" refers to the observed reduction in shear modulus when the stress on an amorphous solid is increased beyond the initial linear region. Careful numerical quasi-static simulations reveal an intimate relation between plastic…
We investigate the propagation of fluid-driven fault slip on a slip-weakening frictional interface separating two identical half-spaces of a three-dimensional elastic solid. Our focus is on axisymmetric circular shear ruptures as they…