Related papers: 20 GHZ Low Noise LLRF System

The low-level RF (LLRF) systems for linear accelerating structures are typically based on heterodyne architectures. The linear accelerators normally have many RF stations and multiple RF inputs and outputs for each station, so the…

This work demonstrates the first non-reciprocal network based on switched low-loss acoustic delay lines. A 21 dB non-reciprocal contrast between insertion loss (IL=6.7 dB) and isolation (28.3 dB) has been achieved over a fractional…

Radio interferometers provide the means to perform the wide-field-of-view (FoV), high-sensitivity observations required for modern radio surveys. As computing power per cost has decreased, there has been a move towards larger arrays of…

The proposed Next Linear Collider (NLC) contains linac systems operating at L,S,C, and X band. This paper describes a wideband modular low-level RF (LLRF) system applicable for all NLC pulsed RF systems. High speed digital IF techniques are…

We discuss our recent progress in iimproving the phase noise of a semiconductor laser using self-injection locking of to a mode of a high-Q whispering gallery mode resonator. Locking efficiency is analyzed for semiconductor distributed…

We simultaneously achieve clock synchronisation, clock-synchronised data transmission and ultra-low noise RF carrier generation by combining clock phase caching and frequency comb transmission in radio access networks (RAN). We demonstrate…

Precise measurements of the frequency and phase of an electrical or optical signal play a key role in various branches of science and engineering. Tracking changing laser frequencies is especially demanding when the lasers themselves are…

Wireless communication through dynamic spectrum allocation over microwave bands, essential to accommodate exponentially growing data traffic, requires massive array of radio-frequency (RF) filters for adaptive signal shaping at arbitrary…

This work presents the design and preliminary performance of a highly-multiplexed superconducting detector readout. The readout system is implemented on the Xilinx ZCU111 RFSoC Evaluation Board. The current design uses 12% of the DSPs, 60%…

This paper presents FADE-10G - an integrated solution for modern multichannel measurement systems. Its main aim is a low latency, reliable transmission of measurement data from FPGA-based front-end electronic boards (FEBs) to a…

Monolithic integration of multiband (1.4~ 6.0 GHz) RF acoustic devices were successfully demonstrated within the same process flow by using the lithium niobate (LN) thin film on silicon carbide (LNOSiC) substrate. A novel surface mode with…

Low cost, small footprint, highly efficient and mass producible on-chip wavelength-division-multiplexing (WDM) light sources are key components in future silicon electronic and photonic integrated circuits (EPICs) which can fulfill the…

Optically generated microwave signals exhibit some of the lowest phase noise and timing jitter of any microwave-generating technology to date. The success of octave-spanning optical frequency combs in down-converting ultrastable optical…

This paper presents a low-loss optically-controlled inline RF switch suitable for L- and S-band applications. Under 1.5 W laser power, the switch exhibits a measured ON-state insertion loss of less than 0.33 dB and return loss better than…

The Xilinx ZCU111 Radio Frequency System on Chip (RFSoC) is a promising solution for reading out large arrays of microwave kinetic inductance detectors (MKIDs). The board boasts eight on-chip 12-bit / 4.096 GSPS analogue-to-digital…

As the number of qubits in nascent quantum processing units increases, the connectorized RF (radio frequency) analog circuits used in first generation experiments become exceedingly complex. The physical size, cost and electrical failure…

This work describes the LLRF and control system in use for a novel accelerator structure developed for a compact design operating in C-band developed by SLAC, with collaboration from RadiaBeam and RadiaSoft. This design is a pulsed…

This paper presents a discrete-time analog frontend for an analog-to-digital (ADC) based equalizers. The frontend uses a discrete-time linear equalizer (DTLE) and ultralow-power 4-bit time-interleaved charge-steering flash ADC. The DTLE…

Next-generation cellular systems require low-power mm-wave phased-array ICs. Variable-gain LNAs (VG-LNAs) are key blocks enabling reduced hardware complexity, performance improvement and added functionalities. This paper reports a low-power…

The LCLS began operations in 2009, utilizing SLAC's normal-conducting (NC) LINAC, which features control equipment dating back to the 1960s and 1980s. The Linac Electronics Modernization Plan (LEMP) aims to replace the legacy control…