Related papers: Research into the sampling methods of digital beam…

The Beam Loss Monitors (BLM) are designed to measure the position and amount of beam loss in accelerators. In this article, we have studied the 3 GeV electron losses in the storage ring and secondary particles from the losses on the beam…

Mobile users are prone to experience beam failure due to beam drifting in millimeter wave (mmWave) communications. Sensing can help alleviate beam drifting with timely beam changes and low overhead since it does not need user feedback. This…

This paper optimizes the beamforming design of a downlink multiple-input multiple-output (MIMO) dual-function radar-communication (DFRC) system to maximize the weighted communication sum-rate under a prescribed transmit covariance…

In millimeter wave (mmWave) communication systems, beamforming with large antenna arrays is critical to overcome high path losses. Separating all-digital beamforming into analog and digital stages can provide the large reduction in power…

This article investigates beam alignment for multi-user millimeter wave (mmWave) massive multi-input multi-output system. Unlike the existing works using machine learning (ML), an alignment method with partial beams using ML (AMPBML) is…

This paper addresses simultaneous, high-precision measurement and analysis of generic reference signals by using inexpensive commercial off-the-shelf Software Defined Radio hardware. Sine reference signals are digitally down-converted to…

An FPGA based digital signal processing (DSP) system for biasing and reading out multiplexed bolometric detectors for mm-wavelength telescopes is presented. This readout system is being deployed for balloon-borne and ground based cosmology…

This work illustrates and compares some methods to measure the most relevant parameters of silicon photo-multipliers (\sipm{}s), such as photon detection efficiency as a function of over-voltage and wavelength, dark count rate, optical…

The Orthogonal Frequency Division Multiplexing (OFDM) is one of the most widely adopted schemes in wireless technologies such as Wi-Fi and LTE due to its high transmission rates, and the robustness against Intersymbol Interference (ISI).…

Pulsar radio emission undergoes dispersion due to the presence of free electrons in the interstellar medium (ISM). The dispersive delay in the arrival time of pulsar signal changes over time due to the varying ISM electron column density…

This article presents a method that uses turn-by-turn beam position data and k-modulation data to measure the calibration factors of beam position monitors in high energy accelerators. In this method, new algorithms have been developed to…

Training beam design for channel estimation with infinite-resolution and low-resolution phase shifters (PSs) in hybrid analog-digital milimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems is considered in this paper.…

Hybrid digital/analog architecture and low-resolution analog-to-digital/digital-to-analog converters (ADCs /DACs) are two low-cost implementations for large-scale millimeter wave (mmWave) systems. In this paper, we investigate the problem…

Millimeter-wave communication has the potential to deliver orders of magnitude increases in mobile data rates. A key design challenge is to enable rapid beam alignment with phased arrays. Traditional millimeter-wave systems require a high…

Sampling-based motion planners (SBMPs) are widely used to compute dynamically feasible robot paths. However, their reliance on uniform sampling often leads to poor efficiency and slow planning in complex environments. We introduce a novel…

The spatial sensitivity pattern of millimeter-wavelength receivers is an important diagnostic of performance and is affected by the alignment of coupling optics. Characterization can be challenging in the field, particularly in the…

Silicon Photomultipliers (SiPMs) are state-of-the-art photon detectors used in particle physics, medical imaging, and beyond. They are sensitive to individual photons in the optical wavelength regime and achieve time resolutions of a few…

The localization problem in a wireless sensor network is to determine the coordination of sensor nodes using the known positions of some nodes (called anchors) and corresponding noisy distance measurements. There is a variety of different…

Position-sensitive SiPMs are useful in all light detection applications requiring a small number of readout channels while preserving the information about the incoming light's interaction position. Focusing on a 2x2 array of LG-SiPMs…

Despite the recent visually-pleasing results achieved, the massive computational cost has been a long-standing flaw for diffusion probabilistic models (DPMs), which, in turn, greatly limits their applications on resource-limited platforms.…