Related papers: Research into the sampling methods of digital beam…
The Duke storage ring is a dedicated driver for the storage ring based oscillator free-electron lasers (FELs), and the High Intensity Gamma-ray Source (HIGS). It is operated with a beam current ranging from about 1 mA to 100 mA per bunch…
Enhanced-SSFM digital backpropagation (DBP) is experimentally demonstrated and compared to conventional DBP. A 112 Gb/s PM-QPSK signal is transmitted over a 3200 km dispersion-unmanaged link. The intradyne coherent receiver includes…
The Advanced Photon Source (APS) was commissioned in 1995 as a third-generation x-ray user facility. At that time orbit control was performed exclusively with broadband rf beam position monitors (BPMs). Since then, emphasis has been placed…
Accurate mapping and localization are very important for many industrial robotics applications. In this paper, we propose an improved Signed Distance Function (SDF) for both 2D SLAM and pure localization to improve the accuracy of mapping…
Blind face restoration (BFR) is important while challenging. Prior works prefer to exploit GAN-based frameworks to tackle this task due to the balance of quality and efficiency. However, these methods suffer from poor stability and…
Real-time, bunch-by-bunch monitoring of transverse position, longitudinal phase, and bunch length is crucial for beam control in diffraction-limited storage rings, where complex collective dynamics pose unprecedented diagnostic challenges.…
Quantum imaging with spatially entangled photons offers advantages such as enhanced spatial resolution, robustness against noise, and counter-intuitive phenomena, while a biphoton spatial aberration generally degrades its performance.…
Three ultra-short-period W/B4C multilayers (1.244nm, 1.235nm and 1.034nm) have been fabricated and used for polarization measurement at the 4B7B Beamline of Beijing Synchrotron Radiation Facility (BSRF). By rotating analyzer ellipsometry…
Diffusion models (DMs) are a class of generative models that allow sampling from a distribution learned over a training set. When applied to solving inverse problems, the reverse sampling steps are modified to approximately sample from a…
High-precision positioning in GPS-denied environments is a demanding but challenging technology. Resonant Beam Positioning (RBP) utilizes a resonant beam with properties such as energy focusing, self-establishment, self-alignment, and…
This paper presents Bit-Interleaved Coded Modulation metrics for joint estimation detection using training or reference signal transmission strategies for short to long block length channels. We show that it is possible to enhance the…
The estimation of the direction of electromagnetic (EM) waves from a radio source using electrically short antennas is one of the challenging problems in the field of radio astronomy. In this paper we have developed an algorithm which…
An introduction and the status of R&D activities for a high-resolution, "cold" beam position monitor (BPM) and the related read-out electronics are discussed. Two different BPM detector concepts, to be attached to the SC quadrupole and…
This work presents a new frequency acquisition method using semi-rotational frequency detection (SRFD) algorithm for a reference-less clock and data recovery (CDR) in a serial-link receiver. The proposed SRFD algorithm classifies the…
We present the development and characterization of a generic, reconfigurable, low-cost ($<$ 350 USD) software-defined digital receiver system (DRS) for temporal correlation measurements in atomic spin ensembles. We demonstrate the use of…
In massive multiple-input multiple-output (MIMO) systems, the channel estimation scheme is subject to the spatial non-stationarity and inevitably power leakage in the beam domain. In this paper, a beam domain channel estimation scheme is…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
Fourier ptychography microscopy (FPM), sharing its roots with synthetic aperture technique and phase retrieval method, is a recently developed computational microscopic super-resolution technique. By turning on the light-emitting diode…
In this paper, based on directional modulation (DM), robust beamforming matrix design for sum secrecy rate maximization is investigated in multi-user systems. The base station (BS) is assumed to have the imperfect knowledge of the direction…
Transistor random mismatch continuously poses challenges for analog/RF circuit design for achieving high accuracy and high yield as the process technology advances. Existing statistical element selection (SES) design method can improve…