Related papers: Performance study of a Time of Flight Method used …

Time of flight system (TOF) based on MRPC technology is widely used in modern physics experiments, and it also plays an important role in particle identification. With the increase of accelerator energy and luminosity, TOF system is…

A four-gap glass RPC with 0.3mm gap size was tested with hadron beam as a time-of-flight detector having a time resolution of ~ 100ps. A thickness of the detector together with front-end electronics is ~ 12mm. Results on time resolution…

Purpose: To demonstrate a proton imaging system based on well-established fast scintillator technology to achieve high performance with low cost and complexity, with the potential of a straightforward translation into clinical use. Methods:…

The prototype of a TDC board has been developed for the new high granular time-of-flight neutron detector (HGND). The board is based on the standard LVDS 4x asynchronous oversampling using the xc7k160 FPGA with a 100 ps bin width. The HGND…

Timepix3 pixel detectors have demonstrated great potential for tracking applications. With $256\times 256$ pixels, 55 $\mathrm{\mu}$m pitch and improved resolution in time (1.56 ns) and energy (2 keV at 60 keV), they have become powerful…

We developed a time-correlated single-photon counting (TCSPC) system based on the low-jitter superconducting nanowire single-photon detection (SNSPD) technology. The causes of jitters in the TCSPC system were analyzed. Owing to the low…

An online, adaptive method of time delay and magnitude estimation for sinusoidal signals is presented. The method is based on an adaptive gradient descent algorithm that directly determines the time delay and magnitudes of two noisy…

A time-of-flight system was constructed for the STAR Experiment for the direct identification of hadrons produced in 197Au+197Au collisions at RHIC. The system consists of two separate detector subsystems, one called the pVPD (the "start"…

Including the metric fluctuations of a realistic cosmological geometry we reconsider an earlier suggestion that measuring the relative time-of-flight of ultra-relativistic particles can provide interesting constraints on fundamental…

A detailed and accurate characterisation of silicon photomultiplier detectors is required for a better understanding of the signal and noise in many applications. The collected information is a valuable feedback to the manufacturers in…

This paper aims at the problem of time-of-flight (ToF) estimation using channel state information (CSI) obtainable from commercialized MIMO-OFDM WLAN receivers. It was often claimed that the CSI phase is contaminated with errors of known…

We describe the design and performance of a large-area scintillator hodoscope onboard the BESS rigidity spectrometer; an instrument with an acceptance of 0.3 m^{2}sr. The hodoscope is configured such that 10 and 12 counters are respectively…

In this work, a system scheme is proposed for tracking a radio emitting target moving in two-dimensional space. The localization is based on the use of biased time-of-arrival (TOA) measurements obtained at two asynchronous receivers, each…

We investigate the recovery of superconducting NbN-nanowire photon counters after detection of an optical pulse at a wavelength of 1550 nm, and present a model that quantitatively accounts for our observations. The reset time is found to be…

Measuring the cosmic ray flux over timescales comparable to the age of the solar system, $\sim 4.5\,$Gyr, could provide a new window on the history of the Earth, the solar system, and even our galaxy. We present a technique to indirectly…

The precise reconstruction of the turbulent volume is a key point in the development of new-generation Adaptive Optics systems. We propose a new Cn2 profilometry method named CO-SLIDAR (COupled Slope and scIntillation Detection And…

We have developed a novel detector, referred to as an "$\alpha$-ToF detector", for correlated measurements of atomic masses and decay properties of low-yield, short-lived radioactive isotopes using a multi-reflection time-of-flight mass…

This article describes the design, assembly and characterization of a portable cosmic ray detector, developed by the INSULAB group and suitable for teaching activities aimed at high school students. It consists of a compact aluminum…

Detecting the X-ray radialization of pulsars and obtaining the photons' time of arrival are the foundation steps in autonomous navigation via X-ray pulsar measurement. The precision of a pulse' s time of arrival is mainly decided by the…

Archival aerial imagery is a source of worldwide very high resolution data for documenting paste 3-D changes. However, external information is required so that accurate 3-D models can be computed from archival aerial imagery. In this…