Related papers: Pb-doped p-type Bi$_2$Se$_3$ thin films via interf…
Bi$_{2}$Se$_{3}$, one of the most widely studied topological insulators (TIs), is naturally electron-doped due to n-type native defects. However, many years of efforts to achieve p-type Bi$_{2}$Se$_{3}$ thin films have failed so far. Here,…
Magnetic interaction with the gapless surface states in topological insulator (TI) has been predicted to give rise to a few exotic quantum phenomena. However, the effective magnetic doping of TI is still challenging in experiment. Using…
We theoretically investigate the possibility of establishing ferromagnetism in the topological insulator Bi2Se3 via magnetic doping of 3d transition metal elements. The formation energies, charge states, band structures, and magnetic…
Magnetic doping with transition metal ions is the most widely used approach to break timereversal symmetry in a topological insulator, a prerequisite for unlocking the TIs exotic potential. Recently, we reported the doping of Bi2Te3 thin…
BaTiO3 is typically a strong n-type material with tuneable optoelectronic properties via doping and controlling the synthesis conditions. It has a wide band gap that can only harness the ultraviolet region of the solar spectrum. Despite…
In2O3 is a prototype wide-band-gap semiconductor that exhibits metallic conductivity when highly doped with Sn while retaining a high degree of transparency to visible light. It is widely used as a transparent window/electrode in solar…
Topological insulators are novel quantum materials with metallic surface transport, but insulating bulk behavior. Often, topological insulators are dominated by bulk contributions due to defect induced bulk carriers, making it difficult to…
We show that by Ca-doping the Bi2Se3 topological insulator, the Fermi level can be fine tuned to fall inside the band gap and therefore suppress the bulk conductivity. Non-metallic Bi2Se3 crystals are obtained. On the other hand, the Bi2Se3…
Electron irradiation is investigated as a way to dope the topological insulator Bi2Te3. For this, p-type Bi2Te3 single crystals have been irradiated with 2.5 MeV electrons at room temperature and electrical measurements have been performed…
Two-dimensional (2D) $\beta$-TeO$_2$ has gained attention as a promising material for optoelectronic and power device applications, thanks to its transparency and high hole mobility. However, the underlying mechanism behind its $p$-type…
Bismuth selenide (Bi2Se3) is a good topological insulator (TI) with its surface band Dirac point inside the bulk bandgap. However, Bi2Se3 films grown by molecular beam epitaxy (MBE) often require tuning of Fermi level near the Dirac point…
The surface of a topological crystalline insulator (TCI) carries an even number of Dirac cones protected by crystalline symmetry. We epitaxially grew high quality Pb$_{1-x}$Sn$_x$Te(111) films and investigated the TCI phase by in-situ…
The growth and elementary properties of p-type Bi2Se3 single crystals are reported. Based on a hypothesis about the defect chemistry of Bi2Se3, the p-type behavior has been induced through low level substitutions (1 percent or less) of Ca…
The Cu-doped topological insulator Bi$_2$Se$_3$ has recently been found to undergo a superconducting transition upon cooling, raising the possibilities that it is the first known "topological superconductor" or realizes a novel non-Abelian…
Some topological insulators become superconducting when doped with Cu and Pd. Superconductivity in a non-superconductor may be induced by proximity effect: i.e. Contacting a non-superconductor with a superconductor. The superconducting…
Topological insulators embody a new state of matter characterized entirely by the topological invariants of the bulk electronic structure rather than any form of spontaneously broken symmetry. Unlike the 2D quantum Hall or quantum…
Gas molecule doping on the topological insulator Bi2 Se3 surface with existing Se vacancies is investigated using first-principles calculations. Consistent with experiments, NO2 and O2 are found to occupy the Se vacancy sites, remove…
Three-dimensional (3-D) topological insulators (TI) are characterized by the presence of metallic surface states and a bulk band gap. Recently theoretical and experimental studies have shown an induced gap in the surface state bands of TI…
We present a defect-engineering strategy to optimize the transport properties of the topological insulator Bi2Se3 to show a high bulk resistivity and clear quantum oscillations. Starting with a p-type Bi2Se3 obtained by combining Cd doping…
Topological insulators (TIs) are materials with an insulating bulk characterized by a gapped band structure, along with gapless metallic surface states having a Dirac cone with a helical spin structure in momentum space. The helical…