Related papers: A Class D Power Amplifier for Multi-Frequency Eddy…
A novel approach for measuring the electrical resistivity of non-magnetic materials using magnetic force microscopy (MFM) is discussed. In this method, MFM detects magnetic fields generated by eddy currents induced by the oscillation of a…
As a result of improvements in power semiconductors, moderate frequency switching supplies can now provide the hundreds of amps typically required by accelerators with zero-to-peak noise in the kHz region ~0.06% in current or voltage mode.…
A method to measure the electrical resistivity of materials using magnetic-force microscopy (MFM) is discussed, where MFM detects the magnetic field caused by the tip-oscillation-induced eddy current. To achieve high sensitivity, a high…
The 2D/1D multiscale finite element method (MSFEM) is an efficient way to simulate rotating machines in which each iron sheet is exposed to the same field. It allows the reduction of the three dimensional sheet to a two dimensional…
Representations of AC power systems by frequency dependent impedance equivalents is an emerging technique in the dynamic analysis of power systems including power electronic converters. The technique has been applied for decades in DC-power…
An S band SLED-type pulse compressor has been manufactured by IHEP to challenge the 100 MW maximum input power, which means the output peak power is about 500 MW at the phase reversal time. In order to deal with the RF breakdown problem,…
Energy efficiency has emerged as a critical challenge in modern base stations (BSs), as the power amplifier (PA) consumes a substantial portion of the total power due to its limited efficiency. We investigate waveform and mode adaptation to…
A flexible and low-cost device for eddy current non-destructive testing made of off-the-shelf components is described. The proposed system is compact and easy to operate, and it consists of a dual H-bridge stepper motor driver, a coil…
ITER (International Thermonuclear Experimental Reactor) static magnetic field (SMF) test facility requires a DC power supply with low voltage, high current, and high stability. Due to the limitation ofswitching loss, there is a…
Switch-mode power converters are used in various applications to convert between different voltage (or current) levels. They use transistors to switch on and off the input voltage to generate a pulsed voltage whose arithmetic average is the…
In this paper, Multirate Partial Differential Equations (MPDEs) are used for the efficient simulation of problems with 2-level pulsed excitations as they often occur in power electronics, e.g., DC-DC switch-mode converters. The differential…
This letter proposes a high-efficiency dual-band class-F rectifier for wireless power transmission (WPT). The rectifier comprises a dual-band harmonic termination network, a dual-band matching network, a single Schottky diode, and a dc pass…
This paper describes an active power filter (APF) control strategy, which eliminates harmonics and compensates reactive power in a three-phase four-wire power system supplying non-linear unbalanced loads in the presence of non-linear…
In this work we analyze the power scaling potential of amplifying multicore fibers (MCFs) used in coherently-combined systems. In particular, in this study we exemplarily consider rod-type MCFs with 2x2 up to 10x10 Ytterbium doped cores…
This letter proposes a targeted-subharmonic-eliminating pulse density modulation (PDM) method for series-series (SS) compensated wireless power transfer (WPT) systems. The subharmonic frequency components which excite current abnormal…
Large capacitance enhancement is useful for increasing the gate capacitance of field-effect transistors (FETs) to produce low-energy-consuming devices with improved gate controllability. We report strong capacitance enhancement effects in a…
The basic mechanism underlying electric field switching produced by a resonant tunnelling diode (RTD) is analysed and the theory compared with experimental results; agreement to within 12% is achieved. The electro-absorption modulator (EAM)…
This paper presents analytic study and design considerations of flat wire inductors with distributed gaps for high-power and compact DC-DC Converters. The focus is eddy current loss components within the conductors due to fringing and…
A moving magnetic domain wall produces an electromotive force (emf). It is therefore possible to read the state of a magnetic memory device via the emf it produces when subject to an interrogation pulse. It is also possible to amplify…
Based on conventional H-bridge topologies of magnet power supplies, a high-frequency common-mode equivalent model was established. It is pointed out that the two phase legs have complementary effect of common-mode noise under bipolar PWM…