Related papers: 125-211 GHz Low Noise MMIC Amplifier Design for Ra…
A room-temperature mid-infrared (9 um) heterodyne system based on high-performance unipolar optoelectronic devices is presented. The local oscillator (LO) is a quantum cascade laser, while the receiver is an antenna coupled quantum well…
Superconducting Parametric Amplifiers (SPAs) have seen great interest in recent years due to their high gain and quantum limited noise performance. Among these amplifiers, resonant SPAs have been widely developed for experiments where ultra…
The reflecting antenna elements in most reconfigurable intelligent surfaces (RISs) use semiconductor-based (e.g., positive-intrinsic-negative (PIN) diodes and varactors) phase shifters. Although effective, a drawback of this technology is…
As quantum computers based on superconducting qubit processors scale, cryogenic microwave components in the qubit control and readout chain must be appropriately tested and qualified to ensure consistent and high-fidelity quantum…
We report on the design, first observing season, and analysis of data from a new prototype millimeter-wave interferometer, MINT. MINT consists of four 145 GHz SIS mixers operating in double-sideband mode in a compact heterogeneous…
We demonstrate a ventilated metamaterial absorber operating at low frequency (< 500 Hz).With only two layers of the absorption units, high-efficiency absorption (> 90%) has been achieved in both simulations and experiments. This…
In ambient backscatter communication (AmBC), strong direct interference from the ambient source poses a major challenge to reliable symbol detection. Although previous studies have shown that employing a low-noise amplifier (LNA) in…
We achieve high detectivity terahertz sensing using a silicon nitride nanomechanical resonator functionalized with a metasurface absorber. High performances are achieved by striking a fine balance between the frequency stability of the…
In this paper we describe the status of the first prototype of the 60 GHz wireless Multi-gigabit data transfer topology currently under development at University of Heidelberg using IBM 130 nm SiGe HBT BiCMOS technology. The 60 GHz band is…
The Lumped Element Kinetic Inductance Detectors (LEKID)demonstrated full maturity in the NIKA (New IRAM KID Arrays)instrument. These results allow directly comparing LEKID performance with other competing technologies (TES, doped silicon)…
The need for high-temperature piezoelectric microelectromechanical systems (MEMS) requires pushing piezoelectric platforms to their thermal limits. In harsh thermal environments, piezoelectric MEMS devices are expected to sustain severe…
Measurements of the low frequency electrical noise in the ferromagnetic semiconductor (Ga,Mn)As reveal an enhanced integrated noise at low temperature. For moderate localization, we find a 1/f normalized power spectrum density over the…
We demonstrate a low noise, high-gain, resonant optical amplifier that combines injection locking with feed-forward cancellation of residual phase noise. The wavelength-agnostic architecture uses a commercial semiconductor diode laser as a…
Based on the principles of microwave circuit interferometry we have constructed a Reduced Noise Amplifier (RNA) with power spectral density of phase, as well as amplitude, fluctuations close to -170 dBc/Hz at 1 kHz offset. The RNA has been…
Nanomechanical oscillators have been employed as transducers to measure force, mass and charge with high sensitivity. They are also used in opto- or electromechanical experiments with the goal of quantum control and phenomena of mechanical…
A low power cascode SiGe BiCMOS low noise amplifier (LNA) with current reuse and zero-pole cancellation is presented for ultra-wideband (UWB) application. The LNA is composed of cascode input stage and common emitter (CE) output stage with…
Implementation cost and power consumption are two important considerations in modern wireless communications, particularly in large-scale multi-antenna systems where the number of individual radio-frequency (RF) chains may be significantly…
We present measurements of the low-frequency noise of microstrip-coupled, lumped-element aluminum kinetic inductance detectors that use hydrogenated amorphous silicon parallel-plate capacitors (Al/a-Si:H MS-PPC-LEKIDs), which are under…
We report an actuation/detection scheme with a top-down nano-electromechanical system for frequency shift-based sensing applications with outstanding performance. It relies on electrostatic actuation and piezoresistive nanowire gauges for…
The LCLS-II HE superconducting linac can produce multi-energy beams by supporting multiple undulator lines simultaneously. This could be achieved by using the cavity SRF tuner in the off-frequency detune mode. This off-frequency operation…