Related papers: Au-Ge alloys for wide-range low-temperature on-chi…
The low temperature heat capacity C_{p} of Fe_{1-x}Ga_{x} alloys with large magnetostriction has been investigated. The data were analyzed in the standard way using electron ($\gamma T$) and phonon ($\beta T^{3}$) contributions. The Debye…
Cooling nanoelectronic devices below 10 mK is a great challenge since thermal conductivities become very small, thus creating a pronounced sensitivity to heat leaks. Here, we overcome these difficulties by using adiabatic demagnetization of…
A minimum in resistivity as a function of temperature for an as-quenched Au80Co20 ribbon prepared by melt-spinning using a wheel surface speed of 20 m s^{-1} is found at 25 K. No resistivity minimum is found for an as-quenched ribbon using…
Using the strong temperature dependent resistance of a normal metal wire in proximity to a superconductor, we have been able to measure the local temperature of electrons heated by flowing a dc current in a metallic wire to within a few…
We present a thermometry scheme to extract the temperature of a 2DEG by monitoring the charge occupation of a weakly tunnel-coupled 'thermometer' quantum dot using a quantum point contact detector. Electronic temperatures between 97 mK and…
A thermocouple of Au-Ni with only 2.5-micrometers-wide electrodes on a 30-nm-thick Si3N4 membrane was fabricated by a simple low-resolution electron beam lithography and lift off procedure. The thermocouple is shown to be sensitive to heat…
A total of 5 different half-Heusler alloys, two p-type and two n-type with the fifth a charge compensated alloy have been designed and synthesized. The thermophysical properties of these alloys have been investigated in the range 10 K to…
Schottky barrier contact has been fabricated by thermal deposition of Al on (100) Ge (impurity concentration~1010/cm3 at 80K) that shows extrinsic p-type to intrinsic n-type transition near 180K. Both p and n-type Ge exhibits ideal Schottky…
Structural, thermal, resistive and magnetic properties of melt quenched Bi 0.88 Sb 0.12 alloys are reported. The samples are heated at three different temperatures, followed by rapid quenching in liquid nitrogen. Large temperature…
We have studied the resistivity, $\rho$, of a two-dimensional electron system in silicon in the temperature range 200 mK < T < 7.5 K at zero magnetic field at low electron densities, when the electron system is in the insulating regime. Our…
A sensor for thermal and thermodynamic measurements of small magnetic systems have been designed and built. It is based on a 5μm-thick suspended polymer membrane, which has a very low heat capacity (≈ 10-6 J/K at nitrogen…
We demonstrate the excellent temperature sensing property of a chemically synthesized reduced graphene oxide (rGO). It is found that with increase in temperature from 80 to 375K, the resistivity of reduced graphene oxide monotonically…
To develop next-generation electronics and high efficiency energy-harvesting devices, it is crucial to understand how charge and heat are transported at the nanoscale. Metallic atomic-size contacts are ideal systems to probe the quantum…
We report on the development of an induction based low temperature high frequency ac susceptometer capable of measuring at frequencies up to 3.5 MHz and at temperatures between 2 K and 300 K. Careful balancing of the detection coils and…
We report on temperature measurements of nuclear systems formed in the Au+Au collisions at incident energies of 50, 100, 150, 200 and 1000 A MeV. The target spectator matter was studied at the highest energy and the interacting zone…
Superconducting heat switches with extremely low normal state resistances are needed for constructing continuous nuclear demagnetization refrigerators with high cooling power. Aluminum is a suitable superconductor for the heat switch…
This work presents a theoretical study of the electronic structure and transport properties of Ni-Au alloys, recently identified as excellent thermoelectric metals with a power factor significantly exceeding that of conventional…
Polarization-dependent scattering anisotropy of cylindrical nanowires has numerous potential applications in, for example, nanoantennas, photothermal therapy, thermophotovoltaics, catalysis, sensing, optical filters and switches. In all…
Resistance thermometry is a time-tested method for taking temperature measurements. In recent years fundamental limits to resistance-based approaches spurred considerable interest in developing photonic temperature sensors as a viable…
A series of sigma-phase Fe_{100-x}V_x samples with 34.4 < x < 59.0 were investigated by neutron and X-ray diffraction and Mossbauer spectroscopy (MS) techniques. The first two methods were used for verification of the transformation from…