Related papers: Mode I crack tip fields: strain gradient plasticit…
We explore the Mode I fracture toughness of a polymer gel containing a semi-infinite, growing crack. First, an expression is derived for the energy release rate within the linearized, small-strain setting. This expression reveals a crack…
We discuss the stick-slip motion of an elastic block sliding along a rigid substrate. We argue that for a given external shear stress this system shows a discontinuous nonequilibrium transition from a uniform stick state to uniform sliding…
We formulate a phenomenological elasto-plastic theory to describe a solid undergoing a structural transition from a square (p4mm) to an oblique (p2) lattice in two dimensions. Within our theory, the components of the strain may be…
Strong adhesives rely on reduced stress concentrations, often obtained via specific geometry or composition of materials. In many examples in nature and engineering prototypes, the adhesive performance relies on structural rigidity being…
Plastically deforming crystals exhibit scale-free fluctuations that are similar to those observed in driven disordered elastic systems close to depinning, but the nature of the yielding critical point is still debated. Here, we study the…
Mode II fatigue crack growth under reversed shear and static biaxial compression was investigated in two bearing steels. Many aborted branches, quasi-orthogonal to the main crack, were observed along the crack face. The compressive stress…
We present the analytic solution of the Mode III steady-state crack in a square lattice with piecewise linear springs and Kelvin viscosity. We show how the results simplify in the limit of large width. We relate our results to a model where…
We consider a sharp interface kinetic model of phase transitions accompanied by elastic strain, together with its phase-field realization. Quantitative results for the steady-state growth of a new phase in a strip geometry are obtained and…
It is well known experimentally that well-quenched amorphous solids exhibit a plastic instability in the form of a catastrophic shear localization at a well defined value of the external strain. The instability may develop to a shear-band…
On microscopic and mesoscopic scales, plastic flow of crystals is characterized by large intrinsic fluctuations. Deformation by crystallographic slip occurs in a sequence of intermittent bursts ('slip avalanches') with power-law size…
Size-dependence of plastic flow is studied by discrete dislocation dynamical simulation of systems with various numbers of interacting linear edge dislocations while the stress is slowly increased. Regions between avalanches in the…
We study the nucleation and development of crack patterns in thin composite fibers under tension in this work. A fiber comprises an elastic core and an outer layer of a weaker brittle material. In recent tensile experiments on such…
Motivated by some questions arising in the study of quasistatic growth in brittle fracture, we investigate the asymptotic behavior of the energy of the solution $u$ of a Neumann problem near a crack in dimension 2. We consider non smooth…
Slow crack propagation in ductile, and in certain brittle materials, appears to take place via the nucleation of voids ahead of the crack tip due to plastic yields, followed by the coalescence of these voids. Post mortem analysis of the…
Phase field theory for fracture is developed at large strains with an emphasis on a correct introduction of surface stresses. This is achieved by multiplying the cohesion and gradient energies by the local ratio of the crack surface areas…
What characterises a solid is its way to respond to external stresses. Ordered solids, such crystals, display an elastic regime followed by a plastic one, both well understood microscopically in terms of lattice distortion and dislocations.…
Necking instabilities, in which tensile (extensional) deformation localizes into a small spatial region, are generic failure modes in elasto-viscoplastic materials. Materials in this very broad class --- including amorphous, crystalline,…
The propagation of (planar) cracks in a heterogeneous brittle material characterized by a random field of toughness is considered, taking into account explicitly the effect of the crack front roughness on the local stress intensity factor.…
When far from equilibrium, many-body systems display behavior that strongly depends on the initial conditions. A characteristic such example is the phenomenon of plasticity of crystalline and amorphous materials that strongly depends on the…
Localization of plastic strain induced by softening can be objectively described by a regularized plasticity model that postulates a dependence of the current yield stress on a nonlocal softening variable defined by a differential…