Related papers: On the effect of Re addition on microstructural ev…
The microstructural stability and mechanical properties of superalloys at high temperatures are significantly influenced by the composition and nature of the solutes they contain. Most of the alloys with high solvus temperature have higher…
A novel y-y'-y" dual-superlattice superalloy, with promising mechanical properties up to elevated temperatures was recently reported. The present work employs state of the art chemical and spatial characterization techniques to study the…
Cobalt-based alloys with {\gamma}/{\gamma}' microstructures have the potential to become the next generation of superalloys, but alloy compositions and processing steps must be optimized to improve coarsening, creep, and rafting behavior.…
The effect of adding 2 at.% W to a model Ni-Al-Cr superalloy on the morphological evolution, spatial correlations and temporal evolution of g'(L12)-precipitates at 1073 K is studied with scanning electron microscopy and atomic force…
We report evidence of Re and Mo segregation (up to 2.6 at.% and 1 at.%) along with Cr and Co to the dislocations inside of {\gamma}' precipitates in a second generation Ni-based single crystal superalloy, after creep deformation at…
This work presents a detailed investigation into the effect of a low Cu addition (0.01 at.%) on precipitation in an Al-0.80Mg-0.85Si alloy during ageing. The precipitate crystal structures were assessed by scanning transmission electron…
The details of phase separation of a Ni-6.5Al-9.9Mo aged at 978 K for aging times ranging from 0.125 to 1024 h are investigated by atom-probe tomography and lattice-kinetic Monte Carlo (LKMC) simulations. On the basis of the temporal…
In novel Co and CoNi based superalloys, the creep resistance is limited at high temperatures due to low lattice misfit and solvus temperature. In this study, we combined the advantages of Co-Ti (high lattice misfit and solvus temperature)…
We have investigated the structural, magnetic and superconducting properties of [Nb(1.5nm)/Fe(x)]$_{10}$ superlattices deposited on a thick Nb(50nm) layer. Our investigation showed that the Nb(50nm) layer grows epitaxially at 800$^\circ$C…
The combined strengthening effects of grain refinement and high precipitated volume fraction (~6at.%) on the mechanical properties of FeSiTi alloy subjected to SPD processing prior to aging treatment were investigated by atom probe…
This work demonstrates the development of a strong and ductile medium entropy alloy by employing conventional alloying and thermomechanical processing to induce partial recrystallization (PR) and precipitation strengthening in the…
Substitutionally-doped 2D transition metal dichalcogenides are primed for next-generation device applications such as field effect transistors (FET), sensors, and optoelectronic circuits. In this work, we demonstrate substitutional Rhenium…
Ren\'e 41 is a cast and wrought Ni-based superalloy with high yield strength and stress-rupture properties contrasted with poor processability. The aim of this thesis is to systematically investigate the influence of C and B microalloying…
Recent studies on CoNi-based multi-principal element alloys (MPEAs) have demonstrated high strength and ductility, attributed to the formation of stable L12 nanoscale precipitates. However, the fundamental mechanisms behind such impressive…
The effect of composition on microstructure both at the length scale of the secondary dendrite arm spacing and nano-sized dispersoids during homogenization of Al-Zn-Cu-Mg-Zr alloys has been studied. A comprehensive model that can predict…
Precipitation-strengthened alloys, such as Ni-base, Co-base and Fe-base superalloys, show the development of dendrite-like precipitates in the solid state during aging at near-$\gamma^{\prime}$ solvus temperatures. These features arise out…
The microstructural and compositional evolution of intergranular carbides and borides prior to and after creep deformation at 850 $^\circ$C in a polycrystalline nickel-based superalloy was studied. Primary MC carbides, enveloped within…
The tensile creep performance of a polycrystalline Co/Ni-base superalloy with a multimodal gamma prime distribution has been examined at 800C and 300MPa. The rupture life of the alloy is comparable to that of RR1000 tested under similar…
High-temperature, high-dose, neutron irradiation of W results in the formation of Re-rich clusters at concentrations one order of magnitude lower than the thermodynamic solubility limit. These clusters may eventually transform into brittle…
Nucleation and growth of Ti$_3$Al \textalpha{}$_2$ ordered domains in \textalpha{}-Ti--Al--X alloys were characterised using a combination of transmission electron microscopy, atom probe tomography and small angle X-ray scattering. Model…