Related papers: LISA Pathfinder Platform Stability and Drag-free P…
Detecting and coherently characterizing thousands of gravitational-wave signals is a core data-analysis challenge for the Laser Interferometer Space Antenna (LISA). Transient artifacts, or "glitches", with disparate morphologies are…
The self-gravitating instability of a compressible-inviscid fluid cylinder immersed into a self-gravitating tenuous medium of negligible motion is developed. The stability criterion is derived based on the linear perturbation technique.…
The Laser Interferometer Space Antenna is a foreseen gravitational wave detector, which aims to detect $10^{-20}$ strains in the frequency range from 0.1 mHz to 1 Hz. It is a triangular constellation, with equal sides of $2,5 \times 10^9$…
We present a study of the tilt-to-length coupling noise during the LISA Pathfinder mission and how it depended on the system's alignment. Tilt-to-length coupling noise is the unwanted coupling of angular and lateral spacecraft or test mass…
This article reviews the present status of the technology and instrumentation for the joint ESA/NASA gravitational wave detector LISA. It briefly describes the measurement principle and the mission architecture including the resulting…
Each spacecraft in the Laser Interferometer Space Antenna houses a proof mass which follows a geodesic through spacetime. Disturbances which change the proof mass position, momentum, and/or acceleration will appear in the LISA data stream…
The orbital motion of the Laser Interferometer Space Antenna (LISA) introduces modulations into the observed gravitational wave signal. These modulations can be used to determine the location and orientation of a gravitational wave source.…
The Space Technology 7 Disturbance Reduction System (ST7-DRS) is a NASA technology demonstration payload that operated from January 2016 through July of 2017 on the European Space Agency's LISA Pathfinder spacecraft. The joint goal of the…
The structural stability of a lightsail under the laser flux necessary for interstellar flight is studied analytically and numerically. A sinusoidal perturbation is introduced into a two-dimensional thin-film sail to determine if the sail…
The Laser Interferometer Space Antenna (LISA) aims to observe gravitational waves in the mHz regime over its 10-year mission time. LISA will operate laser interferometers between three spacecrafts. Each spacecraft will utilize independent…
LISA is a joint space mission of the ESA and NASA for detecting low frequency gravitational radiation in the band $10^{-5} - 1$ Hz. In order to attain the requisite sensitivity for LISA, the laser frequency noise must be suppressed below…
The Laser Interferometer Space Antenna (LISA) will observe gravitational radiation in the milliHertz band by measuring picometer-level fluctuations in the distance between drag-free proof masses over baselines of approximately five million…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
The Laser Interferometer Space Antenna (LISA) is a future space-based gravitational wave (GW) detector designed to be sensitive to sources radiating in the low frequency regime (0.1 mHz to 1 Hz). LISA's interferometer signals will be…
LISA is a space-based mHz gravitational-wave observatory, with a planned launch in 2034. It is expected to be the first detector of its kind, and will present unique challenges in instrumentation and data analysis. An accurate preflight…
The LISA mission is a space interferometer aiming at the detection of gravitational waves in the [$10^{-4}$,$10^{-1}$] Hz frequency band. In order to reach the gravitational wave detection level, a Time Delay Interferometry (TDI) method…
Tilt-to-length coupling was the limiting noise source in LISA Pathfinder between 20 and 200 mHz before subtraction in post-processing. To prevent the adding of sensing noise to the data by the subtraction process, the success of this…
This paper reports on the methods and results of a theoretical analysis to design an insulator which must provide a thermally quiet environment to test on ground delicate temperature sensors and associated electronics. These will fly on…
Low-noise temperature measurements at frequencies in the milli-Hertz range are needed in the LISA and LISA PathFinder (LPF). The required temperature stability for LISA is around 10 uK/sqrt(Hz) at frequencies down to 0.1 mHz. In this paper…
A ring laser is defined by its perimeter, which directly enters the conversion factor between measured Sagnac frequency and the actual rotation rate. Large ring lasers employed in geodesy and fundamental physics require stability of the…