Related papers: Passive optical gyroscope with double homodyne rea…
In high-precision atomic gravimeters, a rest mass is needed to provide a gravity reference, which is typically the retro-reflecting mirror of the Raman laser beams that addresses the two hyperfine ground states of the specific free-falling…
We present a new technique for sensing optical cavity mode mismatch and alignment by using a cylindrical lens mode converting telescope, radio-frequency quadrant photodiodes, and a heterodyne detection scheme. The telescope allows the…
G-Pisa is an experiment investigating the possibility to operate a high sensitivity laser gyroscope with area less than $1 \rm m^2$ for improving the performances of the mirrors suspensions of the gravitational wave antenna Virgo. The…
State-of-the-art laser frequency stabilization is limited by miniscule length changes caused by thermal noise. In this work, a cavity-length-insensitive frequency stabilization scheme is implemented using strong dispersion in a…
Fundamental sensitivity of an optical interferometric gravitational wave detector increases with increase of the optical power which, in turn, limited because of the opto-mechanical parametric instabilities of the interferometer. We propose…
We resonantly inject polaritons into a microcavity and track them in time and space as they feel a force due to the cavity gradient. This is an example of "slow reflection," as the polaritons, which can be viewed as renormalized photons,…
Aiming at application for gravitational wave (GW) detection, we propose a novel scheme how to obtain quantum back action evading measurements performed on an opto-mechanical cavity, by introducing a negative radiation pressure coupling…
We demonstrate absorber-free passive and hybrid mode-locking at sub-GHz repetition rates using a hybrid integrated extended cavity diode laser around 1550 nm. The laser is based on InP as gain medium and a long Si$_3$N$_4$ feedback circuit,…
Lasing in the bad-cavity regime has promising applications in precision measurement and frequency metrology due to the reduced sensitivity of the laser frequency to cavity length fluctuations. Thus far, relevant studies have been mainly…
A class of multiwavelength Fabry-Perot lasers is introduced where the spectrum is tailored through a non-periodic patterning of the cavity effective index. The cavity geometry is obtained using an inverse scattering approach and can be…
A stable optical resonator has been built using a 30 micrometer-wide, metal-coated microcantilever as one mirror. The second mirror was a 12.7 mm-diameter concave dielectric mirror. By positioning the two mirrors 75 mm apart in a…
We design coupled optical microcavities and report directional light emission from high-$Q$ modes for a broad range of refractive indices. The system consists of a circular cavity that provides a high-$Q$ mode in form of a whispering…
We show experimentally and theoretically that localized pulses can be generated from an electrically biased $200\,\mu$m multi-transverse mode Vertical-Cavity Surface-Emitting Laser. The device is passively mode-locked using optical feedback…
We present a new method for high precision measurements of polarization rotation in the frequency range from 0.2 to 2.2 THz using a fiber coupled time-domain THz spectrometer. A free standing wire-grid polarizer splits THz light into…
We present a hybrid atomic sensor that realizes radio-frequency electric field detection with intrinsic field amplification and polarization selectivity for robust high-sensitivity field measurement. The hybrid sensor incorporates a passive…
Length changes due to thermo-mechanical noise originating from, for example, Brownian motion are a key limiting factor of present day state-of-the-art laser frequency stabilization using Fabry-P\'erot cavities. We present a laser-frequency…
We have developed a linearly-polarized Ytterbium-doped fiber ring laser with single longitudinal-mode output at 1064nm for LISA and other space applications. Single longitudinal-mode selection was achieved by using a fiber Bragg grating…
A polarization-independent reconfigurable frequency selective rasorber (FSR)/absorber with low insertion loss based on diodes is proposed in this paper. The presented structure consists of a lossy layer based on square loops and a bandpass…
Thermal lensing in resonant optical interferometers such as those used for gravitational wave detection is a concern due to the negative impact on control signals and instrument sensitivity. In this paper we describe a method for monitoring…
We report an investigation of laser frequency stabilization using a whispering gallery mode resonator that is temperature stabilized by a dual-mode technique. This dual-mode technique has yielded mode volume temperature instabilities at the…