Related papers: On Low-Resolution ADCs in Practical 5G Millimeter-…
The use of millimeter waves for wireless communications is one of the main technological innovations of 5G systems with respect to previous generations of cellular systems. Their consideration, however, has been up to now mainly restricted…
Synergistic design of communications and radar systems with common spectral and hardware resources is heralding a new era of efficiently utilizing a limited radio-frequency spectrum. Such a joint radar-communications (JRC) model has…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays, such as millimeter wave and massive MIMO systems. Most…
Triggered by the explosion of mobile traffic, 5G (5th Generation) cellular network requires evolution to increase the system rate 1000 times higher than the current systems in 10 years. Motivated by this common problem, there are several…
The capacity of a discrete-time multi-input multi-output (MIMO) Gaussian channel with output quantization is investigated for different receiver architectures. A general formulation of this problem is proposed in which the antenna outputs…
Millimeter wave (mmWave) communication is a promising solution for coping with the ever-increasing mobile data traffic because of its large bandwidth. To enable a sufficient link margin, a large antenna array employing directional…
This paper investigates a hardware-efficient massive multiple-input multiple-output integrated sensing and communication (MIMO-ISAC) system with 1-bit analog-to-digital converters (ADCs)/digital-to-analog converters (DACs). The proposed…
In Massive MIMO base stations (BSs), the hardware design needs to balance high spectral efficiency (SE) with low complexity. The level of hardware impairments (HWIs) indicates how strong the signal distortion introduced by hardware…
This paper considers a multipair amplify-and-forward massive MIMO relaying system with low-resolution ADCs at both the relay and destinations. The channel state information (CSI) at the relay is obtained via pilot training, which is then…
Massive multiple-input multiple-output (MIMO) is an important technology in fifth generation (5G) cellular networks and beyond. To help design the beamforming at the base station, 5G has introduced new support in the form of flexible…
Given the high throughput requirement for 5G, merging millimeter wave technologies and multi-user MIMO seems a very promising strategy. As hardware limitations impede to realize a full digital architecture, hybrid MIMO architectures, using…
Analog-to-digital converters (ADCs) stand for a significant part of the total power consumption in a massive MIMO base station. One-bit ADCs are one way to reduce power consumption. This paper presents an analysis of the spectral efficiency…
This invited paper discusses the challenging task of assessing the millmeter-wave spectrum for the use of 5G mobile systems. 3 key KPIs related to mobile systems, coverage, capacity and mobility are individually assessed and quantified with…
The performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems is limited by the sparse nature of propagation channels and the restricted number of radio frequency (RF) chains at transceivers. The introduction of…
Signal processing in wireless communications, such as precoding, detection, and channel estimation, are basically about solving inverse matrix problems, which, however, are slow and inefficient in conventional digital computers, thus…
In the past decade, $>$1 Gsps ADCs have become commonplace and are used in many modern 5G base station chips. A major driving force behind this adoption is the benefits of digital up/down-conversion and improved digital filtering. Recent…
Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…
The proliferation of networked devices and the surging demand for ubiquitous intelligence have given rise to the artificial intelligence of things (AIoT). However, the utilization of high-resolution analog-to-digital converters (ADCs) and…
In this letter, we investigate the downlink performance of massive multiple-input multiple-output (MIMO) systems where the base station is equipped with one-bit analogto-digital/digital-to-analog converters (ADC/DACs). Considering…
The millimeter wave (mmWave) frequencies offer the potential of orders of magnitude increases in capacity for next-generation cellular wireless systems. However, links in mmWave networks are highly susceptible to blocking and may suffer…