Related papers: A low phase noise microwave frequency synthesizer …
Optical frequency division based on bulk or fiber optics provides unprecedented spectral purity for microwave oscillators. To extend the applications of this approach, the big challenges are to develop miniaturized optical frequency…
We developed a tunnel diode oscillator and characterized its performance, highlighting its potential applications in the quantum state readout of electrons in semiconductors and electrons on liquid helium. This cryogenic microwave source…
We present a silicon optomechanical nanobeam design with a dynamically tunable acoustic mode at 10.2 GHz. The resonance frequency can be shifted by 90 kHz/V^2 with an on-chip capacitor that was optimized to exert forces up to 1 $\mu$N at 10…
Presented is a new algorithm for estimating the frequency of a single-tone noisy signal using linear least squares (LLS). Frequency estimation is a nonlinear problem, and typically, methods such as Nonlinear Least Squares (NLS) (batch) or a…
Phase locking experiments on vortex based spin transfer oscillators with an external microwave current are performed. We present clear evidence of phase locking, frequency pulling, as well as fractional synchronization in this system, with…
The phase noise of low-noise oscillators is conventionally measured by the cross-spectrum method (CSM), which has a complicated setup. We developed an alternative method called zero-crossing analysis with a double recorder setup (ZCA-DRS)…
Optical frequency combs, coherent light sources that connect optical frequencies with microwave oscillations, have become the enabling tool for precision spectroscopy, optical clockwork and attosecond physics over the past decades. Current…
Microwave synthesizers are central to test and measurement systems across applications including wireless communications, radar, spectroscopy, and time and frequency metrology. State-of-the-art microwave sources, however, are fundamentally…
We report on the development of a frequency modulatable 795 nm semiconductor laser based on self-injection locking to a high quality factor whispering gallery mode microresonator. The laser is characterized with residual amplitude…
A wide variety of applications of microwave cavities, such as measurement and control of superconducting qubits, magnonic resonators, and phase noise filters, would be well served by having a highly tunable microwave resonance. Often this…
Frequency-stable lasers enable high-fidelity quantum state manipulation, which forms the basis of optical atomic clocks, quantum sensing, and quantum computation. Performing state manipulations at increasingly high speeds requires attention…
A Langevin approach to understand the noise of microwave devices is presented. The device is represented by its equivalent circuit with the internal noise sources included as stochastic processes. From the circuit network analysis, a…
We report a bound on the relative frequency fluctuations in nonlinear second harmonic generation. A 1064nm Nd:YAG laser is used to read out the phase of a Mach-Zehnder interferometer while PPKTP, a nonlinear crystal, is placed in each arm…
We present a method for analyzing the phase noise of oscillators based on feedback driven high quality factor resonators. Our approach is to derive the phase drift of the oscillator by projecting the stochastic oscillator dynamics onto a…
Numerous biological and microscale systems exhibit synchronization in noisy environments. The theory of such noisy oscillators and their synchronization has been developed and experimentally demonstrated, but inferring the noise intensity…
A 20 GHz LLRF system is being built using a two-board(RF Front End + ADC/DAC/FPGA) architecture. The RF Front End provides 8 down-converting channels and 3 up-converting channels (5.5-20 GHz RF to 0.05-3 GHz IF). Separate, phase locked,…
The value of residual phase noise, after phase compensation, is one of the key limitations of performance improvement for continuous-variable quantum key distribution using a local local oscillator (LLO CV-QKD) system, since it is the major…
The frequency stability achieved by an optical atomic clock ultimately depends on the coherence of its local oscillator. Even the best ultrastable lasers only allow interrogation times of a few seconds, at present. Here we present a…
This paper presents a low-area and low-power consumption CMOS differential current controlled oscillator (CCO) for neuromorphic applications. The oscillation frequency is improved over the conventional one by reducing the number of MOS…
Lasers with hertz-level linewidths on timescales up to seconds are critical for precision metrology, timekeeping, and manipulation of quantum systems. Such frequency stability typically relies on bulk-optic lasers and reference cavities,…