Related papers: High permittivity processed SrTiO3 for metamateria…
Potassium tantalate (KTaO$_{3}$) is a promising material for dielectric applications at low temperature. However, dense and single-phase ceramics cannot be obtained by conventional sintering because of the evaporation of potassium that…
Barium titanate (BaTiO3) ceramics with a different content of carbon were synthesized by spark-plasma sintering (SPS) at the temperature of 1100 C in vacuum under pressure. The concentration and distribution of carbon impurity inside the…
A new flash (ultra-rapid) spark plasma sintering method applicable to various materials systems, regardless of their electrical resistivity, is developed. A number of powders ranging from metals to electrically insulative ceramics have been…
Flash sintering is an approach allowing reducing the sintering time to mere seconds. To improve the microstructures and the properties of flash sintered specimens, this process has been successfully adapted to pressure assisted sintering…
The perovskite (1-x)YMnO$_3$-xBiFeO$_3$ binary system is very promising because of its multiferroic end members. Nanocrystalline phases have been recently obtained by mechanosynthesis across the system, and the perovskite structural…
The paper demonstrates the prospects of Spark Plasma Sintering (SPS) for the high-speed diffusion welding of the high-strength ultrafine-grained (UFG) near-a Ti-5Al-2V alloy. The effect of increased diffusion welding intensity in the UFG Ti…
Textured alumina ceramics were obtained by Spark Plasma Sintering (SPS) of undoped commercial a-Al2O3 powders. Various parameters (density, grain growth, grain size distribution) of the alumina ceramics, sintered at two typical temperatures…
We optimize the superconducting properties of Sm-based oxypnictide (Sm1111: SmFeAsO0.80F0.20) by using the Spark Plasma Sintering (SPS) technique under various synthesis conditions, including heating temperatures ranging from 600 to 1000…
NaTaO3-50wt% Fe2O3 composite ceramics showed a large Seebeck voltage of -300 mV at a temperature gradient of 650 K yielding a constant Seebeck coefficient of more than -500 microV/K over a wide temperature range. We report for the first…
An energy efficient spark plasma sintering method enabling the densification of large size samples assisted by very low electric current levels is developed. In this method, the electric current is concentrated in the graphite foils around…
The dielectric properties of strontium titanate (SrTiO$_3$) have previously been reported from room temperature to low temperatures with conflicting results. In this work, precision measurement of the permittivity is undertaken by…
The quasi-static anisotropic permittivity parameters of electrically insulating gallium oxide (beta-Ga2O3) were determined by terahertz spectroscopy. Polarization-resolved frequency domain spectroscopy in the spectral range from 200 GHz to…
The results of dynamic strength tests of the alumina ceramics with various grain sizes are presented. The ceramics were obtained by Spark Plasma Sintering (SPS) of industrial submicron and fine Al2O3 powders. The heating up was performed…
This manuscript presents a novel method for characterizing the permittivities of low-loss dielectric slabs in sub-terahertz (sub-THz) frequencies, specifically above 100 GHz using a quasi-optical system. The algorithm is introduced with…
Spark plasma sintering (SPS) technique is applied in combination with hydrogen decrepitation process for the recycling of SmCo5 magnets. The SmCo5 magnets for recycling were first decrepitated by hydrogen gas of a pressure of 4 bar for 3…
Spintronic terahertz (THz) emitter provides the advantages such as apparently broader spectrum, significantly lower cost, and more flexibility in compared with the commercial THz emitters, and thus attracts great interests recently. In past…
Three types of BaTiO3 core - amorphous nano-shell composite ceramics were processed from the same core-shell powder by standard sintering, spark-plasma sintering and two-step sintering techniques and characterized by XRD, HRSEM and…
This work addresses the two great challenges of the spark plasma sintering (SPS) process: the sintering of complex shapes and the simultaneous production of multiple parts. A new controllable interface method is employed to concurrently…
Silicate ceramics are of considerable promise as high frequency dielectrics in emerging millimetre wave applications including high bandwidth wireless communication and sensing. In this review, we show how high quality factors and low,…
We show that 3D Dirac semimetals are promising candidates for highly efficient optical-to-terahertz conversion due to their extreme optical nonlinearities. In particular, we predict that the conversion efficiency of Cd3As2 exceeds typical…