Related papers: Thin-film based ultralow noise SQUID magnetometer
Considering the growing interest in magnetic materials for unconventional computing, data storage, and sensor applications, there is active research not only on material synthesis but also characterisation of their properties. In addition…
In the past, magnetic images acquired using scanning Superconducting Quantum Interference Device (SQUID) microscopy have been interpreted using simple models for the sensor point spread function. However, more complicated modeling is needed…
We report results of investigation of the low-frequency excess noise in device channels made from topological insulators - a new class of materials with a bulk insulating gap and conducting surface states. The thin-film bismuth selenide…
We have studied a Superconducting Quantum Interference SQUID device made from a single layer thin film of superconducting silicon. The superconducting layer is obtained by heavily doping a silicon wafer with boron atoms using the Gas…
Inductance is a key parameter when optimizing the performance of superconducting quantum interference device (SQUID) magnetometers made from the high temperature superconductor YBa$_2$Cu$_3$O$_{7-x}$ (YBCO) because lower SQUID inductance…
We present a fabrication method of superconducting quantum interference devices (SQUIDs) based on direct write lithography with an Atomic Force Microscope (AFM). This technique involves maskless local anodization of Nb or NbN ultrathin…
Significant advancements have been made in understanding the physics of transition-edge sensors (TESs) over the past decade. However, key questions remain, particularly a detailed understanding of the current-dependent resistance of these…
Josephson junction spectroscopy is a powerful local microwave spectroscopy technique that has promising potential as a diagnostic tool to probe the microscopic origins of noise in superconducting qubits. We present advancements toward…
We characterize a niobium-based superconducting quantum interference proximity transistor (Nb-SQUIPT) built upon a Nb-Cu-Nb SNS weak link. The Nb-SQUIPT and SNS devices are fabricated simultaneously in two separate lithography and…
Here a minimum power dissipation coil transducer has been designed to allow in-flight noise characterization of a low-frequency magnetic measurement system. The coil was produced using PCB technology to provide mechanical stability and easy…
Direct imaging of impressed dc currents inside the head can provide valuable conductivity information, possibly improving electro-magnetic neuroimaging. Ultra-low field magnetic resonance imaging (ULF MRI) at $\mu$T Larmor fields can be…
We investigate thin film resistive thermometry based on metal-to-insulator-transition (niobium nitride) materials down to very low temperature. The variation of the NbN thermometer resistance have been calibrated versus temperature and…
We present transport measurements of unshunted dc superconducting quantum interference devices (SQUIDs) consisting of 30 nm wide aluminum nanobridges of varying length L contacted with two and three dimensional banks. 3D nanobridge SQUIDs…
Micron-sized superconducting interference devices ($\mu$-SQUIDs) based on constrictions optimized for minimizing thermal runaway are shown to exhibit voltage oscillations with applied magnetic flux despite their hysteretic behavior. We…
The critical current density of a superconducting film can be easily determined by an inductive and contactless method. Driving a sinusoidal current in a single coil placed in front of a superconducting sample, a non zero third harmonic…
We present noise measurements performed on a YBa$_2$Cu$_3$O$_{7-\delta}$ nanoscale weak-link-based magnetometer consisting of a Superconducting QUantum Interference Device (SQUID) galvanically coupled to a $3.5 \times 3.5~$mm$^2$ pick-up…
We use low-temperature scanning electron microscopy combined with SQUID detection of magnetic flux to image vortices and to investigate low-frequency flux noise in YBa$_2$Cu$_3$O$_7$ thin film SQUIDs. The low-frequency flux noise shows a…
Brownian thermal noise of thin-film coatings is a fundamental limit for high-precision experiments based on optical resonators such as gravitational-wave interferometers. Here we present the results of a research activity aiming to develop…
Levitated nanoparticles and microparticles are excellent candidates for the realization of extremely isolated mechanical systems, with a huge potential impact in sensing applications and in quantum physics. Magnetic levitation based on…
We propose a single photon detector based on a superconducting quantum interference device (SQUID) with superconductor-normal metal-superconductor Josephson weak links. One of the two Josephson junctions is connected to an antenna, and is…