Related papers: Improved Control Strategies for Intermittent Conta…
Balancing high sensitivity with a broad dynamic range is a fundamental challenge in measurement science, as improving one often compromises the other. While traditional quantum metrology has prioritized enhancing local sensitivity, a large…
Modeling contact mechanics with high contrast coefficients presents significant mathematical and computational challenges, especially in achieving strongly symmetric stress approximations for mixed formulations. Due to the inherent…
We propose a novel type of optomechanical coupling which enables a tripartite interaction between a quantum emitter, an optical mode and a macroscopic mechanical oscillator. The interaction uses a mechanism we term mode field coupling:…
Spin squeezing in atomic ensembles enables atom interferometry with sensitivities below the shot-noise limit, but the associated entanglement is highly susceptible to loss, making imperfections in atom optics a central limitation. Bragg…
Stretchable conductors are of crucial relevance for emerging technologies such as wearable electronics, low-invasive bioelectronic implants or soft actuators for robotics. A critical issue for their development regards the understanding of…
The force sensor is key to the performance of atomic force microscopy (AFM). Nowadays, most AFMs use micro-machined force sensors made from silicon, but piezoelectric quartz sensors are applied at an increasing rate, mainly in vacuum. These…
We investigate the prospect of enhancing the phase sensitivity of atom interferometers in the Mach-Zehnder configuration with squeezed light. Ultimately, this enhancement is achieved by transferring the quantum state of squeezed light to…
Continuum robots offer high flexibility and multiple degrees of freedom, making them ideal for navigating narrow lumens. However, accurately modeling their behavior under large deformations and frequent environmental contacts remains…
Inhomogeneities in the refractive index of a biological sample can introduce phase aberrationsin microscopy systems, severely impairing the quality of images. Adaptive optics can be employed to correct for phase aberrations and improve…
Commercial atomic force microscopes usually use a four-segmented photodiode to detect the motion of the cantilever via laser beam deflection. This read-out technique enables to measure bending and torsion of the cantilever separately. A…
Asymmetric Mach-Zehnder interferometers (AMZIs) can, in principle, enable continuous wavelength tuning of a laser when used as an intra-cavity filter. Their simplicity and good compatibility with generic foundry platforms are major…
We analyze an advanced two-spring model with an ultra-low effective tip mass to predict nontrivial and physically rich 'fine structure' in the atomic stick-slip motion in Friction Force Microscopy (FFM) experiments. We demonstrate that this…
We demonstrate a high performance AOM based bi-frequency interferometer, which can realize either beating or beating free interference for single photon level quantum state. Visibility and optical efficiency of the interferometer are (99.5…
Microscopy is an essential tool in scientific research, enabling the visualization of structures at micro- and nanoscale resolutions. However, the field of microscopy often encounters limitations in field-of-view (FOV), restricting the…
Active control of friction by ultrasonic vibration is a well-known effect with numerous technical applications ranging from press forming to micromechanical actuators. Reduction of friction is observed with vibration applied in any of the…
Fast contact detection is crucial for safe human-robot collaboration. Observers based on proprioceptive information can be used for contact detection but have first-order error dynamics, which results in delays. Sensor fusion based on…
Micromanipulation systems leverage automation and robotic technologies to improve the precision, repeatability, and efficiency of various tasks at the microscale. However, current approaches are typically limited to specific objects or…
Intercalation of two dimensional materials, particularly transition metal dichalcogenides, is a noninvasive way to modify electronic, optical and structural properties of these materials. However, research of these atomic-scale phenomena…
We describe here the implementation of an interferometer-based microwave impedance microscope on a home-built tuning-fork based scanning probe microscope (SPM). Tuning-fork based SPMs, requiring only two electrical contacts for…
Using optical tweezers and a haptic device, microspheres having diameters ranging from 3 to 4 um (floating in a fluid solution) are manipulated in order to form patterns of coupled optical microresonators by assembling the spheres via…