Related papers: ADC Bit Allocation under a Power Constraint for Mm…
The estimation of millimeter wave (mmWave) massive multiple input multiple output (MIMO) channels becomes compelling when one-bit analog to digital converters (ADCs) are utilized. Furthermore, as the number of antenna increases, pilot…
Receivers for mmWave systems suffer from high power consumption in Analog to Digital Converters (ADC), and there is a need to compare the three major receiver architectures: Analog, Hybrid and Digital Combining (AC, HC and DC). Moreover,…
In this paper, we introduce a novel approach to user-centric association and feedback bit allocation for the downlink of a cell-free massive MIMO (CF-mMIMO) system, operating under limited feedback constraints. In CF-mMIMO systems employing…
Millimeter wave (MmWave) has been regarded as a promising technology to support high-capacity communications in 5G era. However, its high-layer performance such as latency and packet drop rate in the long term highly depends on resource…
Movable antennas (MAs) are a promising paradigm to enhance the spatial degrees of freedom of conventional multi-antenna systems by flexibly adapting the positions of the antenna elements within a given transmit area. In this paper, we model…
In this paper, we propose and evaluate two novel double-sequence low-resolution frequency synchronization methods in millimeter-wave (mmWave) systems. In our system model, the base station uses analog beams to send the synchronization…
Low-resolution digital-to-analog and analog-to-digital converters (DACs and ADCs) have attracted considerable attention in efforts to reduce power consumption in millimeter wave (mmWave) and massive MIMO systems. This paper presents an…
We propose a novel linear minimum-mean-squared-error (MMSE) precoder design for a downlink (DL) massive multiple-input-multiple-output (MIMO) scenario. For economical and computational efficiency reasons low resolution 1-bit…
The massive Multiple-Input Multiple-Output (mMIMO) concept has been recently moving forward to extreme scales to address the envisioned requirements of next generation networks. However, the extension of conventional architectures will…
Millimeter wave (mmWave) communications has been regarded as a key enabling technology for 5G networks. In contrast to conventional multiple-input-multiple-output (MIMO) systems, precoding in mmWave MIMO cannot be performed entirely at…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…
This paper considers an uplink multiuser massive multiple-input-multiple-output (MIMO) system with low-resolution analog-to-digital converters (ADCs), in which K users with a single-antenna communicate with one base station (BS) with Nr…
Real-world wireless transmitter front-ends exhibit certain nonlinear behavior, e.g., signal clipping by a Power Amplifier (PA). Although many resource allocation solutions do not consider this for simplicity, it leads to inaccurate results…
We present a novel iterative detection and decoding scheme for the uplink of large-scale multiuser multiple-antenna systems. In order to reduce the receiver's energy consumption and computational complexity, 1-bit analog-to-digital…
Millimeter wave (mmWave) signals experience orders-of-magnitude more pathloss than the microwave signals currently used in most wireless applications. MmWave systems must therefore leverage large antenna arrays, made possible by the…
Hybrid analog-digital precoding is challenging for broadband millimeter-wave (mmWave) massive MIMO systems, since the analog precoder is frequency-flat but the mmWave channels are frequency-selective. In this paper, we propose a principal…
The use of one-bit analog-to-digital converters (ADCs) at a receiver is a power-efficient solution for future wireless systems operating with a large signal bandwidth and/or a massive number of receive radio frequency chains. This solution,…
Cell-Free Massive Multiple-input Multiple-output (mMIMO) consists of many access points (APs) in a coverage area that jointly serve the users. These systems can significantly reduce the interference among the users compared to conventional…
Integrated sensing and communication (ISAC) is a promising technology for future mobile networks, enabling sensing applications to be performed by existing communication networks, consequently improving the system efficiency. Millimeter…