Related papers: Direct current parallel microdischarges in helium
Micro hollow cathode discharges (MHCD) were produced using 250 m thick dielectric layer of alumina sandwiched between two nickel electrodes of 8 m thickness. A through cavity at the center of the chip was formed by laser drilling technique.…
This paper describes how to light several microdischarges in parallel without having to individually ballast each one. The V-I curve of a microhollow cathode discharge is characterized by a constant voltage in the normal glow regime because…
Microplasma arrays operating in helium in a DC regime have been produced in silicon microre-actors. Cathode boundary layer (CBL) type microdevices were elaborated using clean room facilities and semiconductor processing techniques. Ignition…
A device has been built and tested, in which a ceramic superconducting cathode and a copper anode cause electrical discharges in low pressure gases, at temperatures between 50 and 70 K. The electrodes are connected to a capacitors array…
The axial light distributions in parallel-plate dc microdischarges in argon show similar behavior to large scale discharges. Between the low-current Townsend mode and the high current glow mode exists a large region of currents where…
A numerical study of normal glow discharge properties was performed in the case of small electrodes separations (0.05-0.4 cm) and moderate gas pressures (10-46 Torr). A recently observed new experimental effect of a considerable reduction…
We report in this paper simulation results and experimental measurements to characterize a micro-discharge generated in a single micro cavity device operating in helium. By spatially limiting the cathode surface area using a dielectric…
Axial emission profiles in a parallel plate dc micro discharge (feedgas: argon; discharge gap d=1mm; pressure p=10Torr) were studied by means of time resolved imaging with a fast ICCD camera. Additionally, volt-ampere (V-A) characteristics…
We have constructed an apparatus to study DC electrical breakdown in liquid helium at temperatures as low as 0.4 K and at pressures between the saturated vapor pressure and $\sim$600 torr. The apparatus can house a set of electrodes that…
Two-dimensional capacitively coupled radio frequency discharge in methane is simulated by PIC-MCC method. The results were obtained in pressure range 50-300 mTorr and voltage range 40-180 V for discharge frequency 13.56 MHz. The electron…
The impact of convective flow due to the temperature gradient between discharge cell electrodes and ambient air was studied for parallel-plate electrode arrangement. It was shown that an increase in temperature during the discharge…
Next-generation cryogenic transmission electron microscopes (TEM) aim to achieve high-resolution imaging at ultracold sample temperatures (< 90 K) and over extended hold times. Lower temperatures enable atomic-scale characterization with…
A nonequilibrium distribution function of microscopic thermal current is studied by a direct numerical simulation in a thermal conducting steady state of particle systems. Two characteristic temperatures of the thermal current are…
We report results from a study on electrical breakdown in liquid helium using near-uniform-field stainless steel electrodes with a stressed area of $\sim$0.725 cm$^2$. The distribution of the breakdown field is obtained for temperatures…
In this work, we focus on plasma discharges produced between two electrodes with a high potential difference, resulting in the ionization of the neutral particles supporting a current in the gaseous medium. At low currents and low…
This article presents an investigation of a transient (30 {\mu}s - 5 ms) electrical discharge in metal vapour with low voltage (< 50 V) and current (< 1 A), drawn between two separating electrodes. Discharges of this type are rarely…
The investigations of powerful discharge in high density hydrogen were carried out on an installation with preliminary adiabatic compression. The experiments were performed under the following conditions: stored energy of the capacitive…
Thermal voltage noise measurements are performed in order to determine the electron temperature in nanopatterned channels of a GaAs/AlGaAs heterostructure at bath temperatures of 4.2 and 1.4 K. Two narrow two-dimensional (2D) heating…
Stable DC atmospheric pressure normal glow discharges in ambient air were produced between the water surface and the metallic capillary coupled with influx of helium gas. Multiple independent repeated trials indicated that vibrational…
We present transport measurements of electrons on the surface of liquid helium in a microchannel device in which a constriction may be formed by a split-gate electrode. The surface electron current passing through the microchannel first…