Related papers: Feasibility studies for a wireless 60 GHz tracking…

Stationary collectors reading wireless, battery powered smart meters, often operate in harsh channel conditions to cut network installation cost to a minimum, challenging the individual link to each meter. The desired performance measure is…

For the Phase-II Upgrade of the ATLAS detector at CERN, the current ATLAS Inner Detector will be replaced with the ATLAS Inner Tracker. The ATLAS Inner Tracker will be an all-silicon detector, consisting of a pixel tracker and a strip…

Many concepts for future generations of wireless communication systems use coherent processing of signals from many distributed antennas. The aim is to improve communication reliability, capacity, and energy efficiency and provide…

In the beyond fifth-generation (B5G) and upcoming sixth-generation (6G) wireless communication systems, millimeter (mmWave) wave technology is a promising solution for offering additional bandwidth resources and mitigating spectrum…

ATLAS is a multipurpose experiment at the LHC. The tracking system of ATLAS, embedded in a 2 T solenoidal field, is composed of different technologies: silicon planar sensors (pixel and microstrips) and drift-tubes. The procedure used to…

WiFi signal has become accessible everywhere, providing high-speed data transmission experience. Besides the communication service, channel state information (CSI) of the WiFi signals is widely employed for numerous Internet of Things (IoT)…

With the severe spectrum shortage in conventional cellular bands, millimeter wave (mmW) frequencies between 30 and 300 GHz have been attracting growing attention as a possible candidate for next-generation micro- and picocellular wireless…

In this work, we present the results of a wideband measurement campaign at 60 GHz conducted inside a Linkker electric city bus. Targeting prospective millimeter-wave (mmWave) public transportation wearable scenarios, we mimic a typical…

Next-generation wireless networks must enable emerging technologies such as augmented reality and connected autonomous vehicles via wide range of wireless services that span enhanced mobile broadband (eMBB), as well as ultra-reliable…

Large-scale deployment of Internet of Things (IoT) networks in the industrial, scientific, and medical (ISM) band leads to spectrum congestion and requires multiple gateways to cover wide areas. This will increase cost, complexity, and…

Non-line-of-sight (NLOS) sensing has the potential to enable use cases like intrusion detection in occluded areas, increasing the value provided by Integrated Sensing and Commu- nications (ISAC) in future 6G cellular networks. In this…

The High Luminosity upgrade of the CERN Large Hadron Collider (HL-LHC) requires new high-radiation tolerant silicon pixel sensors for the innermost part of the tracking detector in the CMS experiment. The innermost layer of the tracker,…

Since the spread of the wearable systems and the implementation of the forthcoming 5G in many devices, the question about the assessment of the exposure in wearable typical usage to millimeter waves is crucial and timely. For such…

Seamless redundancy layered atop Wi-Fi has been shown able to tangibly increase communication quality, hence offering industry-grade reliability. However, it also implies much higher network traffic, which is often unbearable as the…

We summarize the R&D activities on a novel semitransparent microstrip sensor to be used on laser-based alignment systems for silicon trackers. The new sensor is used both for particle tracking and laser detection. The aim of this research…

In order to take full advantage of the U.S. Department of Energy's billion-dollar investments into the next-generation research infrastructure (e.g., exascale, light sources, colliders), advances are required not only in detector technology…

The radiation hardness of passive CMOS pixel sensors fabricated in 150 nm LFoundry technology is investigated. CMOS process lines are especially of interest for large-scale silicon detectors as they offer high production throughput at…

The need for high data rate communication systems has been dramatically increasing in recent years. The millimeter-wave bands (such as 60 GHz) have been investigated for wireless high data rate transmission. At these frequencies, the…

Pixel sensors based on commercial high-voltage CMOS processes are an exciting technology that is considered as an option for the outer layer of the ATLAS inner tracker upgrade at the High Luminosity LHC. Here, charged particles are detected…

For the ATLAS Pixel Detector fast readout electronics has been successfully developed and tested. Main attention was given to the ability to detect small charges in the order of 5,000 electrons within 25 ns in the harsh radiation…