Related papers: The FE-I4 Telescope for particle tracking in testb…
A new pixel detector for the CMS experiment was built in order to cope with the instantaneous luminosities anticipated for the Phase~I Upgrade of the LHC. The new CMS pixel detector provides four-hit tracking with a reduced material budget…
The upgraded Inner Tracking System (ITS2) of the ALICE experiment at the CERN Large Hadron Collider is based on Monolithic Active Pixel Sensors (MAPS). With a sensitive area of about 10 $m^2$ and 12.5 billion pixels, ITS2 represents the…
When testing and calibrating particle detectors in a test beam, accurate tracking information independent of the detector being tested is extremely useful during the offline analysis of the data. A general-purpose Silicon Beam Tracker (SBT)…
The ALICE ITS3 (Inner Tracking System 3) upgrade project and the CERN EP R&D on monolithic pixel sensors are investigating the feasibility of the Tower Partners Semiconductor Co. 65 nm process for use in the next generation of vertex…
3D Silicon sensors fabricated at FBK-irst with the Double-side Double Type Column (DDTC) approach and columnar electrodes only partially etched through p-type substrates were tested in laboratory and in a 1.35 Tesla magnetic field with a…
In June 2008 single-sided silicon strip sensors with 50 $\mu$m readout pitch were tested in a highly energetic pion beam at the SPS at CERN. The purpose of the test was to evaluate characteristic detector properties by varying the strip…
We present the results of a beam test conducted on a telescope using the JadePix-3 pixel sensor, developed with TowerJazz 180 nm CMOS imaging technology. The telescope is composed of five planes, each equipped with a JadePix-3 sensor with…
In order to meet the requirements of the High Luminosity LHC (HL-LHC), it will be necessary to replace the current tracker of the ATLAS experiment. Therefore, a new all-silicon tracking detector is being developed, the so-called Inner…
In view of the high luminosity phase of the LHC (HL-LHC) to start operation around 2026, a major upgrade of the tracker system for the ATLAS experiment is in preparation. The expected neutron equivalent fluence of up to 2.4 * 1e16 1 MeV…
Following the Phase-II upgrade during Long Shutdown (LS3), the LHC aims to reach a peak instantaneous luminosity of $7.5\times 10^{34}$cm$^{-2}$s$^{-1}$, which corresponds to an average of around 200 inelastic proton-proton collisions per…
Small-pitch 3D silicon pixel detectors have been investigated as radiation-hard candidates for the innermost layers of the HL-LHC pixel detector upgrades. Prototype 3D sensors with pixel sizes of 50$\times$50 and 25$\times$100 $\mu$m$^{2}$…
The ATLAS experiment, at the Large Hadron Collider, will incorporate discrete, high-resolution tracking sub-systems in the form of segmented silicon detectors with 40MHz radiation-hard readout electronics. In the region closest to the pp…
The Inner Tracking System (ITS) of the ALICE experiment at CERN will undergo an upgrade during the LHC long shutdown 3, in which the three innermost tracking layers will be replaced. This upgrade, named the Inner Tracking System 3 (ITS3),…
We describe the main components of the ATLAS Forward Physics project, namely the movable beam pipe, the tracking and timing detectors which allow to detect intact protons in the final state at the LHC. The position detector is composed on 6…
A novel modular high-resolution charged-particle tracking detector design using $250\mu m$ diameter, round, scintillating fibers and SiPM arrays for readout is presented. The fiber modules consist of 8 layers of 128 fibers, mechanically sta…
We present an R&D activity focused on the development of novel modules for the upgrade of the ATLAS pixel system at the High Luminosity LHC (HL-LHC). The modules consist of n-in-p pixel sensors, 100 or 200 $\mu$m thick, produced at VTT…
We present an innovative charge detector with high resolution and wide dynamic range designed to fulfill the requirements of a monitoring system for a high energy ion beam. The detector prototype, constructed using Si photodiodes and a…
The 3D silicon sensor has demonstrated excellent performances (signal collection, detection efficiency, power consumption, etc.) comparable or even better with respect to the traditional planar sensor of the ATLAS Detector at the Large…
We present results of a study of charged particle track and vertex reconstruction with a beam telescope made of four layers of 50 micron-thin CMOS monolithic pixel sensors using the 120 GeV protons at the FNAL Meson Test Beam Facility. We…
During 2014 the second experimental area EAR2 was completed at the n-TOF neutron beam facility at CERN. As the neutrons are produced via spallation, by means of a high-intensity 20 GeV pulsed proton beam impinging on a thick target, the…