Related papers: Fast Control Latency Uncertainty Elimination for t…

The Beijing Spectrometer III (BESIII) endcap Time-Of-Filght (ETOF) was proposed to upgrade with Multigap Resistive Plate Chamber (MRPC) technology to substitute the current ETOF of scintillator+PMT for extending time resolutin better than…

An automatic clock synchronizing method implemented in field programmable gate array (FPGA) is proposed in this paper. It is developed for the clock system which will be applied in the end-cap time of flight (ETOF) upgrade of the Beijing…

The prototype of time digitizing system for the upgrade of BESIII endcap TOF (ETOF) is introduced in this paper. The ETOF readout electronics has a formation of distributed architecture that hit signal from multi-gap resistive plate chamber…

It is proposed to upgrade the endcap time-of-flight (ETOF) of the Beijing Spectrometer III (BESIII) with multi-gap resistive plate chamber (MRPC), aiming at overall time resolution about 80 ps. After the entire electronics system is ready,…

PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor…

A GEANT4-based Monte-Carlo model is developed to study the performance of Endcap Time-Of-Flight (ETOF) at BESIII. It's found that the multiple scattering effects, mainly from the materials at the MDC endcap, can cause multi-hit on the…

An upgraded Beam Emission Spectroscopy (BES) system has been deployed to access low amplitude turbulence regions near internal transport barriers on the DIII-D tokamak. Sixteen high sensitivity channels are being installed. A significant…

The STAR experiment at RHIC at Brookhaven National Laboratory completed the installation of an endcap time-of-flight subsystem (eTOF) in February 2019. The eTOF subsystem provided essential mid-rapidity particle identification (PID) for the…

In bipartite consensus tracking (BCT) tasks for nonlinear multiagent systems, stochastic disturbances and actuator faults are regarded as essential factors that hamper effective controller formulation and tracking precision improvement. To…

Time of flight cameras may emerge as the 3-D sensor of choice. Today, time of flight sensors use phase-based sampling, where the phase delay between emitted and received, high-frequency signals encodes distance. In this paper, we present a…

With the decrease in system inertia, frequency security becomes an issue for power systems around the world. Energy storage systems (ESS), due to their excellent ramping capabilities, are considered as a natural choice for the improvement…

The results of a full simulation of an endcap Time-of-Flight detector upgrade based on multigap resistive plate chambers for the BESIII experiment are presented. The simulation and reconstruction software is based on Geant4 and has been…

A Time of Flight monitoring system has been developed for BES3. The light source is a 442-443 nm laser diode, which is stable and provides a pulse width as narrow as 50 ps and a peak power as large as 2.6 W. Two optical-fiber bundles with a…

In order to further enhance the particle identification capability of the Beijing Spectrometer (BESIII), it is proposed to upgrade the current end-cap time-of-flight (eTOF) detector with multi-gap resistive plate chamber (MRPC). The…

Precise and ultrafast control of electronic band structures is a central challenge for advancing quantum functional materials and devices. Conventional approaches--such as chemical doping, lattice strain, or external gating--offer robust…

Tunable lasers are essential for optical communication, spectroscopy, and precision sensing, where flexible and fast control of the laser wavelength is needed. However, conventional tunable laser systems often rely on mechanical actuation,…

During the last years the transfer of frequency signals through optical fibers has shown ultra low instabilities in various configurations. The outstanding experimental results of such point-to-point connections is motivation to develop a…

In wireless sensor networks, a few sensor nodes end up being vulnerable to potentially rapid depletion of the battery reserves due to either their central location or just the traffic patterns generated by the application. Traditional…

This paper introduces FANTF (Fuzzy Attention Network-Based Transformers), a novel approach that integrates fuzzy logic with existing transformer architectures to advance time series forecasting, classification, and anomaly detection tasks.…

Dual-system UAVs with vertical take-off and landing capabilities have become increasingly popular in recent years. As a safety-critical system, it is important that a dual-system UAV can maintain safe flight after faults/failures occur.…