Related papers: Joint Crosstalk-Avoidance and Error-Correction Cod…
We consider distributed computations between two parties carried out over a noisy channel that may erase messages. Following a noise model proposed by Dani et al. (2018), the noise level observed by the parties during the computation in our…
We consider the problem of error control in a coded, multicast network, focusing on the scenario where the errors can occur only on a proper subset of the network edges. We model this problem via an adversarial noise, presenting a formal…
The receiver design for multi-input multi-output (MIMO) ultra-reliable and low-latency communication (URLLC) systems can be a tough task due to the use of short channel codes and few pilot symbols. Consequently, error propagation can occur…
Communications in dispersive direct-sequence code-division multiple-access (DS-CDMA) channels suffer from intersymbol and multiple-access interference, which can significantly impair performance. Joint maximum \textit{a posteriori}…
In this paper, we will present an analysis on the fault erasure BP decoders based on the density evolution. In the fault BP decoder, messages exchanged in a BP process are stochastically corrupted due to unreliable logic gates and…
Channel coding for 6G networks is expected to support a wide range of requirements arising from heterogeneous communication scenarios. These demands challenge traditional code-specific decoders, which lack the flexibility and scalability…
The prevalence of quantum crosstalk in current quantum devices poses challenges for achieving high-fidelity quantum logic operations and reliable quantum processing. Through quantum control theory, we develop an analytical condition for…
Batched sparse (BATS) codes were proposed as a reliable communication solution for networks with packet loss. In the finite-length regime, the error probability of BATS codes under belief propagation (BP) decoding has been studied in the…
Readout errors contribute significantly to the overall noise affecting present-day quantum computers. However, the complete characterization of generic readout noise is infeasible for devices consisting of a large number of qubits. Here we…
In a digital communication system, information is sent from one place to another over a noisy communication channel. It may be possible to detect and correct errors that occur during the transmission if one encodes the original information…
Measurement for qubits plays a key role in quantum computation. Current methods for classifying states of single qubit in a superconducting multi-qubit system produce fidelities lower than expected due to the existence of crosstalk,…
Some state-of-art multimedia source encoders produce embedded source bit streams that upon the reliable reception of only a fraction of the total bit stream, the decoder is able reconstruct the source up to a basic quality. Reliable…
Recent work on approximate quantum error correction (QEC) has opened up the possibility of constructing subspace codes that protect information with high fidelity in scenarios where perfect error correction is impossible. Motivated by this,…
In order to correct the pair-errors generated during the transmission of modern high-density data storage that the outputs of the channels consist of overlapping pairs of symbols, a new coding scheme named symbol-pair code is proposed. The…
The problem of joint source-channel coding is considered for a stationary remote (noisy) Gaussian source and a Gaussian channel. The encoder and decoder are assumed to be causal and their combined operations are subject to a delay…
We study two fundamental problems in communication, Document Exchange (DE) and Error Correcting Code (ECC). In the first problem, two parties hold two strings, and one party tries to learn the other party's string through communication. In…
We provide a general formulation for the code-based test compression problem with fixed-length input blocks and propose a solution approach based on Evolutionary Algorithms. In contrast to existing code-based methods, we allow unspecified…
We consider transmission over a binary-input additive white Gaussian noise channel using low-density parity-check codes. One of the most popular techniques for decoding low-density parity-check codes is the linear programming decoder. In…
In this chapter, we show how the use of differential coding and the presence of phase slips in the transmission channel affect the total achievable information rates and capacity of a system. By means of the commonly used QPSK modulation,…
The design of block codes for short information blocks (e.g., a thousand or less information bits) is an open research problem that is gaining relevance thanks to emerging applications in wireless communication networks. In this paper, we…