Related papers: Iterative Eigenvalue Decomposition and Multipath-G…
In many wireless communication applications, it is desirable to transmit the same data to multiple user equipments (UEs). Physical layer multicasting presents an efficient transmission topology to exploit the beamforming capabilities at the…
We propose a multicarrier chirp-division multiplexing (MCDM) system in which orthogonal chirp waveforms are utilized as frequency subcarriers. Orthogonal characteristics of chirp subcarriers are analyzed in respect to cross-correlation…
Millimeter Wave (mm-w), especially the 60 GHz band, has been receiving much attention as a key enabler for the 5G cellular networks. Beamforming (BF) is tremendously used with mm-w transmissions to enhance the link quality and overcome the…
In order to address the asynchronous interference issue for a generalized scenario with multiple primary and multiple secondary receivers, in this paper, we propose an innovative cooperative beamforming technique. In particular, the…
Pareto optimal solutions are conceived for radar beamforming error (RBE) and sum rate maximization in short-packet (SP) millimeter-wave (mmWave) integrated sensing and communication (ISAC). Our ultimate goal is to realize ultra-reliable…
In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…
Millimeter wave (mmWave) communication is one feasible solution for high data-rate applications like vehicular-to-everything communication and next generation cellular communication. Configuring mmWave links, which can be done through…
In this paper, we investigate an intelligent reflect surface (IRS) assisted multi-user millimeter wave (mmWave) downlink communication system, exploiting IRS to alleviate the blockage effect and enhance the performance of the mmWave system.…
The pinching-antenna system (PASS) reconstructs wireless channels through pinching beamforming, i.e., optimizing the activated locations of pinching antennas (PAs) along the waveguide. The aim of this article is to investigate the joint…
Training sequences are designed to probe wireless channels in order to obtain channel state information for block-fading channels. Optimal training sounds the channel using orthogonal beamforming vectors to find an estimate that optimizes…
Dual-function radar-communication (DFRC) systems, which can efficiently utilize the congested spectrum and costly hardware resources by employing one common waveform for both sensing and communication (S&C), have attracted increasing…
While millimeter wave (mmWave) communications promise high data rates, their sensitivity to blockage and severe signal attenuation presents challenges in their deployment in urban settings. To overcome these effects, we consider a…
Integrated Sensing and Communication (ISAC) has attracted substantial attraction in recent years for spectral efficiency improvement, enabling hardware and spectrum sharing for simultaneous sensing and signaling operations. In-band Full…
This work proposes an iterative channel estimation, detection and decoding (ICEDD) scheme for the uplink of multi-user multi-antenna systems assisted by multiple reconfigurable intelligent surfaces (RIS)}. A novel iterative code-aided…
Analog beamforming holds great potential for future terahertz (THz) communications due to its ability to generate high-gain directional beams with low-cost phase shifters. However, conventional analog beamforming may suffer substantial…
Accurate day-ahead peak load forecasting is crucial not only for power dispatching but also has a great interest to investors and energy policy maker as well as government. Literature reveals that 1% error drop of forecast can reduce 10…
To efficiently utilize the wireless spectrum and save hardware costs, the fifth generation and beyond (B5G) wireless networks envisage integrated sensing and communications (ISAC) paradigms to jointly access the spectrum. In B5G systems,…
Millimeter wave (mmWave) signals experience orders-of-magnitude more pathloss than the microwave signals currently used in most wireless applications. MmWave systems must therefore leverage large antenna arrays, made possible by the…
We investigate fast data aggregation via over-the-air computation (AirComp) over wireless networks. In this scenario, an access point (AP) with multiple antennas aims to recover the arithmetic mean of sensory data from multiple wireless…
As a key enabling technology for 5G wireless, millimeter wave (mmWave) communication motivates the utilization of large-scale antenna arrays for achieving highly directional beamforming. However, the high cost and power consumption of RF…