Related papers: Iterative Eigenvalue Decomposition and Multipath-G…
Fifth generation (5G) cellular standards are set to utilize millimeter wave (mmWave) frequencies, which enable data speeds greater than 10 Gbps and sub-centimeter localization accuracy. These capabilities rely on accurate estimates of the…
The millimeter wave (mmWave) technology enables unmanned aerial vehicles (UAVs) to offer broadband high-speed wireless connectivity in fifth generation (5G) and beyond (6G) networks. However, the limited footprint of a single UAV…
Via collaborative beamforming, nodes in a wireless network are able to transmit a common message over long distances in an energy efficient fashion. However, the process of making available the same message to all collaborating nodes…
In millimeter wave (mmWave) systems, the advanced lens antenna array can effectively reduce the radio frequency chains cost. However, the mmWave signal is still vulnerable to blocking obstacles and suffers from severe path loss. To address…
In this paper, we investigate a self-sensing intelligent reflecting surface (IRS) aided millimeter wave (mmWave) integrated sensing and communication (ISAC) system. Unlike the conventional purely passive IRS, the self-sensing IRS can…
Integrated super-resolution sensing and communication (ISSAC) has emerged as a promising technology to achieve extremely high precision sensing for those key parameters, such as the angles of the sensing targets. In this paper, we propose…
This paper proposes a novel approach for designing channel estimation, beamforming and scheduling jointly for wideband massive multiple input multiple output (MIMO) systems. With the proposed approach, we first quantify the maximum number…
The availability of large bandwidth at millimeter wave (mmWave) frequencies is one of the major factors that rendered very high frequencies a promising candidate enabler for fifth generation (5G) mobile communication networks. To confront…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
Joint radar-communications (JRC) benefits from multi-functionality of radar and communication operations using same hardware and radio frequency (RF) spectrum resources. Thus JRC systems possess very high potential to be employed into the…
Opportunistic scheduling and beamforming schemes have been proposed previously by the authors for reduced-feedback MIMO-OFDMA downlink systems where the MIMO channel of each subcarrier is decomposed into layered spatial subchannels. It has…
To reap the active and passive beamforming gain in an intelligent reflecting surface (IRS)-aided wireless network, a typical way is to first acquire the channel state information (CSI) relying on the pilot signal, and then perform the joint…
In this paper, we investigate beamforming design and trajectory optimization for a multi-unmanned aerial vehicle (UAV)-assisted integrated sensing and communication (ISAC) system. The proposed system employs multiple UAVs equipped with…
This paper investigates flexible beamforming design in an integrated sensing and communication (ISAC) network with movable antennas (MAs). A bistatic radar system is integrated into a multi-user multiple-input-single-output (MU-MISO)…
Energy beamforming has emerged as a promising technique for enhancing the energy transfer efficiency of wireless power transfer (WPT). However, the performance of conventional energy beamforming may seriously degrade due to the non-linear…
Integrating sensing and communication (ISAC) has emerged as a cornerstone technology for predictive beamforming in 6G-enabled vehicle-to-everything (V2X) networks. However, existing ISAC paradigms rely solely on radio frequency (RF) signal,…
We propose a hybrid architecture that integrates RF (i.e., sub-6 GHz) and millimeter wave (mmWave) technologies for 5G cellular systems. In particular, communications in the mmWave band faces significant challenges due to variable channels,…
In this paper, we investigate the hybrid beamforming design for a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where a multi-antenna base station (BS) with hybrid analog-digital transmit antenna…
Dynamic metasurface antennas (DMAs) provide a new paradigm to realize large-scale antenna arrays for future wireless systems. In this paper, we study the downlink millimeter wave (mmWave) DMA systems with limited number of radio frequency…
In this paper, we propose a joint beamforming algorithm for a multiuser wireless information and power transfer (MU-WIPT) system that is compatible with the conventional multiuser multiple input multiple output (MU-MIMO) system. The…