Related papers: Power dissipation and electrical breakdown in blac…
The potential of bulk black-phosphorus for thermoelectric applications has been experimentally studied. The Seebeck Coefficient (S) has been measured in the temperature range from 300 K to 385 K, finding a value of S = +335 +- 10 uV/K at…
Black phosphorus exhibits a layered structure similar to graphene, allowing mechanical exfoliation of ultrathin single crystals. Here we demonstrate few-layer black phosphorus field effect devices on Si/SiO$_2$ and measure charge carrier…
With a semiconducting band gap and high charge carrier mobility, two-dimensional (2D) black phosphorus (BP), often referred to as phosphorene, holds significant promise for next generation electronics and optoelectronics. However, as a 2D…
Atomic layers of black phosphorus (P) isolated from its layered bulk make a new two-dimensional (2D) semiconducting crystal with sizable direct bandgap, high carrier mobility, and promises for 2D electronics and optoelectronics. However,…
Black phosphorus has been revisited recently as a new two-dimensional material showing potential applications in electronics and optoelectronics. Here we report the anisotropic in-plane thermal conductivity of suspended few-layer black…
The electronic properties of the layered black phosphorus (black-P) and its monolayer counterpart phosphorene are investigated by using the first-principles calculations based on the density functional theory (DFT). The room-temperature…
Black phosphorus has attracted interest as a material for use in optoelectronic devices due to many favorable properties such as a high carrier mobility, field-effect, and a direct bandgap that can range from 0.3 eV in its bulk crystalline…
Few-layer black phosphorus has recently emerged as a promising candidate for novel electronic and optoelectronic device. Here we demonstrate by first-principles calculations and Boltzmann theory that, black phosphorus could also have…
Graphene, as a passivation layer, can be used to protect the black phosphorus from the chemical reaction with surrounding oxygen and water. However, black phosphorus and graphene heterostructures have low efficiency of heat dissipation due…
Thermoelectric devices that utilize the Seebeck effect convert heat flow into electrical energy and are highly desirable for the development of portable, solid state, passively-powered electronic systems. The conversion efficiencies of such…
Black phosphorus is a monoatomic semiconducting layered material that degrades exothermically in the presence of light and ambient contaminants. Its degradation dynamics remain largely unknown. Even before degradation, local-probe studies…
The electric field effect is a useful means of elucidating intrinsic material properties as well as for designing functional devices. The electric-double-layer transistor (EDLT) enables the control of carrier density in a wide range, which…
We measure the temperature distribution in a biased single-layer graphene transistor using Raman scattering microscopy of the 2D-phonon band. Peak operating temperatures of 1050 K are reached in the middle of the graphene sheet at 210 KW…
Recently rediscovered black phosphorus is a layered semiconductor with promising electronic and photonic properties. Dynamic control of its bandgap can enable novel device applications and allow for the exploration of new physical…
Black phosphorus is a layered semiconductor that is intensely researched in view of applications in optoelectronics. In this Letter, we investigate a multi-layer black phosphorus photo-detector that is capable of acquiring high-contrast…
The dissipation of energy in dynamic force microscopy is usually described in terms of an adhesion hysteresis mechanism. This mechanism should become less efficient with increasing temperature. To verify this prediction we have measured…
We study a thermal gradient induced current $\left(I_{th}\right)$ flow in potassium-doped two-dimensional anisotropic black phosphorus (BP) with semi-Dirac dispersion. The prototype device is a BP channel clamped between two contacts…
Isolation and characterization of mechanically exfoliated black phosphorus flakes with a thickness down to two single-layers is presented. A modification of the mechanical exfoliation method, which provides higher yield of atomically thin…
Black phosphorus has recently emerged as a promising material for high performance electronic and optoelectronic device for its high mobility, tunable mid-infrared bandgap and anisotropic electronic properties. Dynamical evolution of photo…
This paper presents a novel method to estimate the power consumption of distinct active components on an electronic carrier board by using thermal imaging. The components and the board can be made of heterogeneous material such as plastic,…