Related papers: Vertical coupling of laser glass microspheres to b…
We have demonstrated the fabrication and characterization of 2D liquid-based multimode optical waveguide structures over a Polydimethylsiloxane (PDMS) material-based chip. Fabrication of two separate microstructures, one with a width of 14…
We report the fabrication of diverse light guiding structures embedded in oxidised porous silicon (OPS) by means of patterned pore filling through a single photoresist mask. The pores of OPS were filled with KDP salt from unsaturated…
A method is presented for fabrication of femtosecond laser written waveguides in glass to remove the need for polishing of substrates after processing. It is shown that by amplitude masking the fabrication laser beam near the sample edge…
Efficient and reliable light coupling between optical fibers and photonic integrated circuits has arguably been the most essential issue in integrated photonics for optical interconnects, nonlinear signal conversion, neuromorphic computing,…
On-chip erbium-doped optical amplifiers and lasers are essential for realizing fully integrated active silicon photonic circuits, but their performance has been limited by the low gain of amorphous host materials and the difficulty of…
We present an efficient method for computing lightcurves of an elliptical source which is microlensed by a point mass. The amplification of an extended source involves a two-dimensional integral over its surface brightness distribution. We…
Fibre optic technology connects the world through the Internet, enables remote sensing, and connects disparate functional optical devices. Highly confined silicon photonics promises extreme scale and functional integration. However, the…
Laser trapping near the surface of a nanostructured substrate is demonstrated. Stable microbubbles with radii of 1-20micrometers have been created and manipulated with sub-micron precision by a focused laser beam in an immersion oil…
We demonstrate an external cavity laser formed by combining a silicon nitride photonic integrated circuit with a reflective semiconductor optical amplifier. The laser uses an alignment tolerant edge coupler formed by a multi-mode waveguide…
We demonstrate electrically pumped III-nitride edge-emitting laser diodes (LDs) with nanoporous bottom cladding. The LD structure was grown by plasma-assisted molecular beam epitaxy. Highly doped 350 nm thick GaN:Si cladding layer with Si…
We report on two edge-coupling and power splitting devices for hybrid integration of III-V lasers with sub-micrometric silicon-on-insulator (SOI) waveguides. The proposed devices relax the horizontal alignment tolerances required to achieve…
We overcome the difficulty in realizing a monolithic waveguide-coupled microring laser integrated on erbium-doped thin film lithium niobate (Er: TFLN) using photolithography assisted chemo-mechanical etching (PLACE) technique. We…
Broadband mid-infrared light sources are highly desired for wide-ranging applications that span free-space communications to spectroscopy. In recent years, silicon has attracted great interest as a platform for nonlinear optical wavelength…
An efficient electro-optical modulation has been demonstrated here by using an edge plasmon mode specific for the hybrid plasmonic waveguide. Our approach addresses a major obstacle of the integrated microwave photonics caused by the…
UV laser irradiation (lambda = 193 nm), below and above damage thresholds, is used to both alter and pattern the surface properties of borosilicate slides to tune and control the contact angle of a water drop over the surface. Large…
Applications such as augmented and virtual reality (AR/VR), optical atomic clocks, and quantum computing require photonic integration of (near-)visible laser sources to enable commercialization at scale. The heterogeneous integration of…
We fabricate and characterize a microscale silicon electro-opto-mechanical system whose mechanical motion is coupled capacitively to an electrical circuit and optically via radiation pressure to a photonic crystal cavity. To achieve large…
Writing optical waveguides with femtosecond laser pulses provides the capability of forming three-dimensional photonic circuits for manipulating light fields in both linear and nonlinear manners. To fully explore this potential, large…
We describe a technique for surface and sub-surface micro-machining of glass substrates using tightly focused femtosecond laser pulses at a wavelength of 1660 nm. Although silicate glass is normally transparent at this wavelength, the…
We investigate the applicability of the coupled multipole model and its modification in the framework of the zero-order Born approximation for modeling of light focusing by finite-size nanostructures of silicon nanospheres, supporting…