Related papers: Modeling of high-efficiency silicon solar cells in…
We develop a new approach to calculate the obtainable limit of photoconversion efficiency of tandem solar cells (SCs) and applied it to SCs with both vertical and lateral designs at AM0 and AM1.5 conditions. To get the maximum efficiency,…
Since the photoconversion efficiency $\eta$ of the silicon-based solar cells (SCs) under laboratory conditions is approaching the theoretical fundamental limit, further improvement of their performance requires theoretical modeling and/or…
Solar modules are currently characterized at standard test conditions (STC), defined at 1000W/m2 and 25 {\deg}C. However, solar modules in actual outdoor operating conditions typically operate at lower illumination and higher temperature…
Thin crystalline silicon solar photovoltaics holds great potential for reducing the module price by material saving and increasing the efficiency by reduced bulk recombination loss. However, the module efficiency decreases rather…
We obtain theoretical expressions for the photocurrent in the Heterojunction solar cells with Intrinsic Thin layer (HIT cells). Our calculations take into account tunneling of electrons and holes through wide-bandgap layers of $\alpha$-Si:H…
Surface recombination affects both light-to-electricity and electricity-to-light conversion in solar cells (SCs). Therefore, quantitative analysis and reduction of surface recombination is an important direction in SC research. In this…
Carrier Selective (CS) Silicon solar cells are increasingly explored as a low cost alternative to PN junction Silicon solar cells. While the recent trends on power conversion efficiency are encouraging, the temperature coefficient and hence…
As the 21st century progresses, photovoltaic technology is becoming a major provider of the worlds electricity, while effects of global climate change unfold. This development begs the question: is climate change affecting the energy…
Low cost, highly efficient, and stable solar cells demand low temperature processing, less stringent criteria on materials, and possibility of dynamic recovery from long term degradation: a combination of features unachievable from the…
Solar energy is the most convenient and reliable energy source among all renewable energy resources and an efficient photovoltaic device is required to convert this energy into utilizable energy. Different types of solar cells (SC) are…
The theoretical analysis of photovoltaic conversion efficiency of highly effective silicon solar cells (SC) is performed for n-type and p-type bases. The case is considered when the Shockley-Read-Hall recombination in the silicon bulk is…
The p-type amorphous/ n-type crystalline silicon (P+ a-Si/N+ c-Si) heterojunction was simulated for developing the solar cells with high conversion efficiency and low cost. The characteristic of such cells with different work function of…
We investigate and evaluate the contribution of the ultraviolet radiation spectrum on the temperature and efficiency of commercial crystalline silicon-based photovoltaics (PVs) that operate outdoors. The investigation is performed by…
An isolated single-junction solar cell's temperature in outer space depends only on its radiation exchange with its environment. We consider a cell with zero emissivity below its bandgap and unity above it -- an idealization so far…
To accurately calculate efficiencies $\eta$ of experimentally produced multijunction solar cells (MJSCs) and optimize their parameters, we offer semi-analytical photoconversion formalism that incorporates radiative recombination,…
It is currently possible to fabricate crystalline silicon solar cells with the absorber thickness ranging from a few hundreds of micrometers (conventional wafer-based cells) to devices as thin as $1\,\mu\mathrm{m}$. In this work, we use a…
The radiative recombination, Shokley-Read recombination, frontal-surface and rear-surface recombination and the recombination at the heterojunction boundaries and the recombination in the space charge region are considered in the…
Numerical and semi-analytical models are presented for photon-enhanced-thermionic-emission (PETE) devices. The models take diffusion of electrons, inhomogeneous photogeneration, and bulk and surface recombination into account. The…
We propose a new concept for the design of high-efficiency photocells based on ultra-thin (submicron) semiconductor films of controlled thickness. Using a microscopic model of a thin dielectric layer interacting with incident…
Thermophotovoltaic systems in principle enable utilization of heat that is usually regarded as wasted energy. However, the wavelength selectivity of the thermal emitter required for high efficiencies is rather difficult to control with…