Related papers: A Data Transmission Method Based on Ethernet Physi…
In standard quantum teleportation, the receiver must wait for a classical message from the sender before subsequently processing the transmitted quantum information. However, in port-based teleportation (PBT), this local processing can…
A main distinguishing feature of a wireless network compared with a wired network is its broadcast nature, in which the signal transmitted by a node may reach several other nodes, and a node may receive signals from several other nodes…
Handling the massive number of devices needed in numerous applications such as smart cities is a major challenge given the scarcity of spectrum resources. Dynamic spectrum access (DSA) is seen as a potential candidate to support the…
The Internet of Things (IoT) is ubiquitous thanks to the rapid development of wireless technologies. However, the broadcast nature of wireless transmissions results in great vulnerability to device authentication. Physical layer…
Present state of the art applications in the area of high energy physics experiments (HEP), radar communication, satellite communication and bio medical instrumentation require fault resilient data acquisition (DAQ) system with the data…
Recently, physical layer (PHY) caching has been proposed to exploit the dynamic side information induced by caches at base stations (BSs) to support Coordinated Multi-Point (CoMP) and achieve huge degrees of freedom (DoF) gains. Due to the…
The burgeoning field of on-device AI communication, where devices exchange information directly through embedded foundation models, such as language models (LMs), requires robust, efficient, and generalizable communication frameworks.…
Modern Ethernet switches support many advanced features beyond route learning and packet forwarding such as VLAN tagging, IGMP snooping, rate limiting, and status monitoring, which can be controlled through a programmatic interface.…
This letter proposes a new physical layer authentication mechanism operating at the physical layer of a communication system where the receiver has partial control of the channel conditions (e.g., using an intelligent reflecting surface).…
The increased bandwidth coupled with the large numbers of antennas of several new radio telescope arrays has resulted in an exponential increase in the amount of data that needs to be recorded and processed. In many cases, it is necessary…
For performing successful measurements within limited experimental time, efficient use of preliminary data plays a crucial role. This work shows that a simple feedforward type neural networks approach for learning preliminary experimental…
For a physical layer message authentication procedure based on the comparison of channel estimates obtained from the received messages, we focus on an outer bound on the type I/II error probability region. Channel estimates are modelled as…
Energy efficiency and reliability are vital design requirements of recent industrial networking solutions. Increased energy consumption, poor data access rates and unpredictable end-to-end data access latencies are catastrophic when…
This paper presents a novel method for synthesizing new physical layer modulation and coding schemes for communications systems using a learning-based approach which does not require an analytic model of the impairments in the channel. It…
The data compression technology now is fully developed and widely used in many fields such as communication, multi-media, image information processing and so on. The large physical experiments, especially the ones with Micro-pattern Gas…
The success in the growing wireless standards can be measured by the achievement of quality of service (QoS) specifications by the designers. The IEEE802.11 wireless standards are widely accepted as wireless technology for wireless LAN.…
This paper investigates energy-efficient transmission protocols in relay-assisted federated learning (FL) setup within industrial subnetworks, considering latency and power constraints. In the subnetworks, devices collaborate to train a…
The evolving Fifth Generation New Radio (5G-NR) cellular standardization efforts at the Third Generation Partnership Project (3GPP) brings into focus a number of questions on relevant research problems in physical-layer communications for…
The industry is satisfying the increasing demand for wireless bandwidth by densely deploying a large number of access points which are centrally managed, e.g. enterprise WiFi networks deployed in university campuses, companies, airports…
Transfer learning is a powerful tool enabling model training with limited amounts of data. This technique is particularly useful in real-world problems where data availability is often a serious limitation. The simplest transfer learning…