Related papers: Observation of Parametric Instability in Advanced …
The first generation of ground-based interferometric gravitational wave detectors, LIGO, GEO and Virgo, have operated and taken data at their design sensitivities over the last few years. The data has been examined for the presence of…
We discuss the parametric oscillatory instability in a Fabry-Perot cavity of the Einstein Telescope. Unstable combinations of elastic and optical modes for two possible configurations of gravitational wave third-generation detector are…
We present the analysis of a nonlinear effect of parametric oscillatory instability in power recycled LIGO interferometer with the Fabry-Perot (FP) cavities in the arms. The basis for this effect is the excitation of the additional (Stokes)…
The raw outputs of the detectors within the Advanced Laser Interferometer Gravitational-Wave Observatory need to be calibrated in order to produce the estimate of the dimensionless strain used for astrophysical analyses. The two detectors…
This paper presents an analysis of the transient behavior of the Advanced LIGO suspensions used to seismically isolate the optics. We have characterized the transients in the longitudinal motion of the quadruple suspensions during Advanced…
Gravitational wave emission is expected to arise from a variety of astrophysical phenomena. A new generation of detectors with sensitivity consistent with expectation from such sources is being developed. The Laser Interferometer…
The LIGO experiment aims to detect and study gravitational waves using ground based laser interferometry. A critical factor to the performance of the interferometers, and a major consideration in the design of possible future upgrades, is…
We calculate the parametric instabilities in Fabry-Perot cavities of Advanced VIRGO and LIGO interferometers with different main mode profiles. All unstable combinations of elastic and Stokes modes both for the case with TEM00 and LG33 as a…
A common misconception about laser interferometric detectors of gravitational waves purports that, because the wavelength of laser light and the length of an interferometer's arm are both stretched by a gravitational wave, no effect should…
Optical rigidity in aLIGO gravitational-wave detector, operated on dark port regime, is unstable. We show that the same interferometer with excluded symmetric mechanical mode but with unbalanced arms allows to get stable optical spring for…
The goal of the Laser Interferometric Gravitational-Wave Observatory (LIGO) is to detect and study gravitational waves of astrophysical origin. Direct detection of gravitational waves holds the promise of testing general relativity in the…
In order to detect the rare astrophysical events that generate gravitational wave (GW) radiation, sufficient stability is required for GW antennas to allow long-term observation. In practice, seismic excitation is one of the most common…
Advanced gravitational-wave detectors such as the Laser Interferometer Gravitational-Wave Observatories (LIGO) require an unprecedented level of isolation from the ground. When in operation, they are expected to observe changes in the…
The thermal noise is expected to be one of the main limiting factors on the sensitivity of interferometric gravitational-wave detectors like LIGO and VIRGO. Thermal fluctuations of internal modes of the interferometer's test masses and of…
Three-mode parametric interactions can occur in triply-resonant opto-mechanical systems in which two orthogonal optical modes are coupled with an appropriate mechanical mode. Using an optical cavity with a membrane inside, we report the…
The sensitivity of the Advanced LIGO detectors to gravitational waves can be affected by environmental disturbances external to the detectors themselves. Since the transition from the former initial LIGO phase, many improvements have been…
The Advanced LIGO gravitational wave detectors will be installed starting in 2011, with completion scheduled for 2015. The new detectors will improve the strain sensitivity of current instruments by a factor of ten, with a thousandfold…
The Advanced LIGO gravitational wave detectors are second generation instruments designed and built for the two LIGO observatories in Hanford, WA and Livingston, LA. The two instruments are identical in design, and are specialized versions…
Seismic noise will be the dominant source of noise at low frequencies for ground based gravitational wave detectors, such as LIGO now under construction. Future interferometers installed at LIGO plan to use at least a double pendulum…
The ``optical springs'' regime of the signal-recycled configuration of laser interferometric gravitational-wave detectors is analyzed taking in account optical losses in the interferometer arm cavities. This regime allows to obtain…