Related papers: Baseband and RF Hardware Impairments in Full-Duple…
We consider a wideband integrated access and backhaul system operating in full-duplex mode between the New Radio gNB donor and single user equipment. Due to high power consumption in millimeter wave systems, we use low-resolution…
Delay alignment modulation (DAM) is a novel transmission technique for wireless systems with high spatial resolution by leveraging delay compensation and path-based beamforming, to mitigate the inter-symbol interference (ISI) without…
A photonics-assisted analog wideband RF self-interference (SI) cancellation and frequency downconversion approach for in-band full-duplex (IBFD) multiple-input multiple-output (MIMO) systems with adaptive digital amplitude and delay…
Coherent point-to-multi-point (PtMP) optical network based on digital subcarrier multiplexing (DSCM) has been a promising technology for metro and access networks to achieve cost savings, low latency, and high flexibility. In-phase and…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
In this paper, we investigate the impact of hardware impairments in antenna arrays on the beamforming performance of multi-input multi-output (MIMO) communication systems. We consider two types of imperfections: per-element gain mismatches…
In this paper, a spatial multiplexing multiple-input multiple-output (MIMO) system when hardware along with RF imperfections occur during the communication setup is analytically investigated. More specifically, the scenario of hardware…
In this letter, we consider single-cell, single-user systems wherein uplink and downlink user equipment communicate with a full-duplex relay. Due to the near-far problem, the self-interference (SI) can be 100-1000x the received signal…
This paper studies the cooperation between a primary system and a cognitive system in a cellular network where the cognitive base station (CBS) relays the primary signal using amplify-and-forward or decode-and-forward protocols, and in…
Recent achievement in self-interference cancellation algorithms enables potential application of full-duplex (FD) in 5G radio access systems. The exponential growth of data traffic in 5G can be supported by having more spectrum and higher…
Noteworthy strides continue to be made in the development of full-duplex millimeter wave (mmWave) communication systems, but most of this progress has been built on theoretical models and validated through simulation. In this work, we…
This paper considers the impact of general hardware impairments in a multiple-antenna base station and user equipments on the uplink performance. First, the effective channels are analytically derived for distortion-aware receivers when…
Full-duplex (FD) technology is gaining popularity for integration into a wide range of wireless networks due to its demonstrated potential in recent studies. In contrast to half-duplex (HD) technology, the implementation of FD in networks…
One of the key technologies for the future cellular networks is full duplex (FD)-enabled integrated access and backhaul (IAB) networks operating in the millimeter-wave (mmWave) frequencies. The main challenge in realizing FD-IAB networks is…
The Terahertz band holds a promise to enable both super-accurate sensing and ultra-fast communication. However, challenges arise that severe Doppler effects call for a waveform with high Doppler robustness while severe propagation path loss…
In this article, we consider the problem of loop-back interference suppression for orthogonal frequency division multiplexing (OFDM) signals in amplify-and-forward single-frequency full-duplex relay stations. The loop-back interference…
The performance of optical fiber systems based on nonlinear frequency-division multiplexing (NFDM) or on more conventional transmission techniques is compared through numerical simulations. Some critical issues affecting NFDM…
To keep the hardware costs of future communications systems manageable, the use of low-cost hardware components is desirable. This is particularly true for the emerging massive multiple-input multiple-output (MIMO) systems which equip base…
Real-world transceiver designs for multiple-input multiple-output (MIMO) wireless communication systems are affected by a number of hardware impairments that already appear at the transmit side, such as amplifier non-linearities,…
We consider a wireless system with a full-duplex (FD) access point (AP) that transmits to a scheduled user in the downlink (DL) channel, while receiving data from an user in the uplink (UL) channel at the same time on the same frequency. In…