Related papers: Optimization parameter design for proton irradiati…
As the second stage of the CEPC-SPPC project, SPPC (Super Proton-Proton Collider) aims at exploring new physics beyond the Standard Model. The key design goal for the SPPC accelerator complex is to reach 75 TeV in center of mass energy with…
We report on experimental investigations of proton acceleration from solid foils irradiated with PW-class laser-pulses, where highest proton cut-off energies were achieved for temporal pulse parameters that varied significantly from those…
A compact beam-profile monitor was constructed using a linear contact image sensor attached to a plastic scintillator and tested using a 230 MeV proton beam. The results indicate that the beam distribution can be obtained in real-time, and…
The Fermilab Booster is being upgraded under the Proton Improvement Plan (PIP) to be capable of providing a proton flux of $2.25^{17}$ protons per hour. The intensity per cycle will remain at the present operational $4.3^{12}$ protons per…
High-energy, high-flux collimated proton beams with high repetition rates are critical for applications such as proton therapy, proton radiography, high-energy-density matter generation, and compact particle accelerators. However, achieving…
The efficiency of the beam extraction and collimation systems in circular accelerators with the use of the channeling effect in a bent crystal is determined. The dependences of the extraction efficiency on the geometrical parameters of the…
Purpose: To demonstrate a proton imaging system based on well-established fast scintillator technology to achieve high performance with low cost and complexity, with the potential of a straightforward translation into clinical use. Methods:…
A high-intensity continuous wave (CW) radio frequency quadrupole (RFQ) accelerator is designed for boron neutron capture therapy (BNCT). The transmission efficiency of a 20-mA proton beam accelerated from 30 keV to 2.5 MeV can reach 98.7%…
Ionization profile monitors (IPMs) are widely used in accelerators for non-destructive and fast diagnostics of high energy particle beams. Two such monitors - one vertical and one horizontal - are being developed for installation in the…
The problem of creation of high energy neutrino beams on the basis of modern and future circular proton accelerators with the help of traditional technology seems to be expensive and difficult. Because of this, we propose the solution of…
Bent crystal was extracting 70-GeV protons with average intensity 4*10^11 (as measured in external beamline) per spill of 1.6 s duration, in parallel to the simultaneous work of two internal targets in the accelerator ring. An additional…
We present a setup for highly polarized proton beams using two parallel propagating laser pulses that have a carrier envelope phase difference of $\pi$. This mechanism is examined utilizing particle-in-cell simulations and compared to a…
FLASH radiation therapy calls for the delivery of fast bursted spills of particles with dose delivery times of the order of milliseconds. The requirements overlap with fundamental physics experimental requests that are being studied at…
We demonstrate a scheme for enhanced proton acceleration from near-critical-density targets by splitting a laser pulse into a linearly and a circularly polarized laser pulse. The combination of two laser pulses generates a shock wave as…
The IOTA Proton Injector (IPI), currently under installation at the Fermilab Accelerator Science and Technology facility (FAST), is a machine capable of delivering 20 mA pulses of protons at 2.5 MeV to the Integrable Optics Test Accelerator…
The determination of relative stopping power (RSP) via proton computed tomography (pCT) of a patient is dependent in part on the knowledge of the incoming proton kinetic energies; the uncertainty in these energies is in turn determined by…
Laser ion acceleration is a promising concept for generation of fast ions using a compact laser-solid interaction setup. In this study, we theoretically investigate the feasibility of ion acceleration from the interaction of petawatt-scale…
Laser plasma acceleration at kilohertz repetition rate has recently been shown to work in two different regimes, with pulse lengths of either 30 fs or 3.5 fs. We now report on a systematic study in which a large range of pulse durations and…
Superconducting photoelectron injectors are a promising technique for generating high brilliant pulsed electron beams with high repetition rates and low emittances. Experiments such as ultra-fast electron diffraction, experiments at the…
A new beam injection scheme is proposed for the Fermilab Booster to increase beam brightness. The beam is injected on the deceleration part of the sinusoidal magnetic ramp and capture is started immediately after the injection. During the…