Related papers: High gain two-stage amplifier with positive capaci…
Inspired by the development of over-moded RF component as an undulator, we explored another over-moded structure that could serve the variable coupling for SRF purpose. This application is to fulfill variation of S11 from 0 to -20db with CW…
We present a case study applying the SpecC methodology within a system-level hardware/software co-design flow to a PCM-to-PWM converter, the core of a Class-D audio amplifier. The converter was modeled and explored with SpecC methodology to…
This paper presents a 17 bit analogue-to-digital converter that incorporates mismatch and quantisation noise-shaping techniques into an energy-saving 10 bit successive approximation quantiser to increase the dynamic range by another 42 dB.…
This paper investigates the impact of technological constraints on passive elements in the design of inductively degenerated CMOS low-noise amplifiers (LNAs). A theoretical analysis is combined with circuit simulations in a 130-nm CMOS…
A robust and portable power supply has been developed specifically for charging linear transformer drivers, a modern incarnation of fast pulsed power generators. It is capable of generator +100 kV and -100 kV at 1 mA, while withstanding the…
The effects of reactive loads into amplification is studied. A simplified common emitter circuit configuration was adopted and respective time-independent and time-dependent voltage and current equations were obtained. As phasor analysis…
This paper presents a switch-type attenuator working from 20 to 100 GHz. The attenuator adopts a capacitive compensation technique to reduce phase error. The small resistors in this work are implemented with metal lines to reduce the…
Achieving amplification with high gain and quantum-limited noise is a difficult problem to solve. Parametric amplification using a superconducting transmission line with high kinetic inductance is a promising technology not only to solve…
High-gain amplifiers of electromagnetic signals operating near the quantum limit are crucial for quantum information systems and ultrasensitive quantum measurements. However, the existing techniques have a limited gain-bandwidth product and…
We have characterized a semiconductor amplifier laser system which provides up to 200mW output after a single-mode optical fiber at 780nm wavelength. The system is based on a tapered semiconductor gain element, which amplifies the output of…
Currently, the demand for a better alternative to linear PID controllers is increasing due to the rising expectations of the high-tech industry. In literature, it has been shown that Constant in gain Lead in phase (CgLp) compensators, which…
This paper describes performance of a voltage controlled phase shifter designed for a high average power and a high figure of merit. The device is a reflection-type, resonant phase shifter that utilizes ferroelectric capacitors and…
Due to their superior noise performance, SQUIDs are an attractive alternative to high electron mobility transistors for constructing ultra-low-noise microwave amplifiers for cryogenic use. We describe the use of a lumped element SQUID…
In this paper, a highly-efficient single-switch-regulated resonant wireless power receiver with hybrid modulation is proposed. To achieve both high efficiency and good output voltage regulation, phase shift and pulse width hybrid modulation…
Dynamic comparators are an essential part of low-power analog to digital converters (ADCs) and are referred to as one of the most important building blocks in mixed mode circuits. The power consumption and accuracy of dynamic comparators…
This paper proposes an efficient method for the calculation of the stabilization parameters in RF power amplifiers operating in periodic large-signal regimes. Stabilization is achieved by applying the principles of linear control theory for…
This paper enumerates new architecture of low power dual-edge triggered Flip-Flop (DETFF) designed at 180nm CMOS technology. In DETFF same data throughput can be achieved with half of the clock frequency as compared to single edge triggered…
Using numerical simulations, we show that two coupled qubits can amplify a weak signal about hundredfold. This can be achieved if the two qubits are biased simultaneously by this weak signal and a strong pump signal, both of which having…
A wide swing charge sensitive amplifier (CSA) has been developed, as a part of a front-end electronics (FEE) readout ASIC, for a prototype silicon tungsten (Si-W) based electromagnetic (EM) calorimeter. The CSA, designed in 0.35 $\mu$m…
Quantum mechanics imposes that any amplifier that works independently on the phase of the input signal has to introduce some excess noise. The impossibility of such a noiseless amplifier is rooted into unitarity and linearity of quantum…