Related papers: A self-calibrating optomechanical force sensor wit…
A method to precisely calibrate the oscillation amplitude in Dynamic Scanning Force Microscopy is described. It is experimentally shown that a typical electronics used to process the dynamic motion of the cantilever can be adjusted to…
The center-of-mass position of a single trapped atomic ion is measured and tracked in time with high precision. Employing a near-resonant radio frequency field of wavelength 2.37 cm and a static magnetic field gradient of 19 T/m, the…
Interatomic-force measurements are regularly performed using frequency-modulation atomic force microscopy. This requires conversion of the observed shift in the resonant frequency of a force-sensing cantilever, to the actual force…
The design of an atomic force microscope with an all-fiber interferometric detection scheme capable of atomic resolution at about 500 mK is presented. The microscope body is connected to a small pumped 3He reservoir with a base temperature…
The optomechanical force sensor in non-Markovian environment for a mechanical oscillator is presented. By performing homodyne detection we obtain an generally expression for the output signal. It is shown that the weak force detection is…
We consider an optomechanical system that is composed of a mechanical and an optical mode interacting through a linear and quadratic optomechanical dispersive couplings. The system is operated in an unresolved side band limit with a high…
Cavity optomechanical (COM) sensors, enhanced by quantum squeezing or entanglement, have become powerful tools for measuring ultra-weak forces with high precision and sensitivity. However, these sensors usually rely on linear COM couplings,…
We present an interferometric sensor for investigating macroscopic quantum mechanics on a table-top scale. The sensor consists of pair of suspended optical cavities with a finesse in excess of 100,000 comprising 10 g fused-silica mirrors.…
Mechanical transduction of torque has been key to probing a number of physical phenomena, such as gravity, the angular momentum of light, the Casimir effect, magnetism, and quantum oscillations. Following similar trends as mass and force…
Mechanical resonators based on low-dimensional materials are promising for force and mass sensing experiments. The force sensitivity in these ultra-light resonators is often limited by the imprecision in the measurement of the vibrations,…
Nanomechanical oscillators have been employed as transducers to measure force, mass and charge with high sensitivity. They are also used in opto- or electromechanical experiments with the goal of quantum control and phenomena of mechanical…
This paper proposes techniques to calibrate six-axis force-torque sensors that can be performed in situ, i.e., without removing the sensor from the hosting system. We assume that the force-torque sensor is attached to a rigid body equipped…
Optical forces can set tiny objects into states of coherent mechanical oscillation, also known as mechanical or phonon lasing. We present a novel pumping mechanism in an opto-mechanical photonic crystal that realizes mechanical lasing with…
A new technique for the fabrication of highly sensitive qPlus sensor for atomic force microscopy (AFM) is described. Focused ion beam was used to cut then weld onto a bare quartz tuning fork a sharp micro-tip from an electrochemically…
Optically levitated macroscopic objects are a powerful tool in the field of force sensing, owing to high sensitivity, absolute force calibration, environmental isolation and the advanced degree of control over their dynamics that have been…
Nano- and micromechanical oscillators with high quality (Q) factors have gained much attention for their potential application as ultrasensitive detectors. In contrast to micro-fabricated devices, optically trapped nanoparticles in vacuum…
We present a Casimir force setup based on an all-optical ferrule-top sensor. We demonstrate that the instrument can be used to measure the gradient of the Casimir force between a gold coated sphere and a gold coated plate with results that…
Near-field force measurements at submicron separations can probe Casimir effects and hypothetical short-range interactions, but require cryogenic operation and stable, \textit{in situ} control of separation-dependent backgrounds. We propose…
We report on the implementation of ultracold atoms as a source in a state of the art atom gravimeter. We perform gravity measurements with 10 nm/s 2 statistical uncertainties in a so-far unexplored temperature range for such a high accuracy…
A high sensitivity force sensor based on dielectric microspheres in vacuum, optically trapped by a single, upward-propagating laser beam, is described. Off-axis parabolic mirrors are used both to focus the 1064~nm trapping beam and to…