Related papers: On the calibration of direct-current current trans…
Time-to-Digital Converters (TDCs) are a crucial tool in a wide array of fields, in particular for quantum communication, where time taggers performance can severely affect the quality of the entire application. Nowadays, FPGA-based TDCs…
Capacitance measurement is a useful technique in studying quantum devices, as it directly probes the local particle charging properties, i.e. the system compressibility. Here we report one approach which can measure capacitance from mK to…
Comparators are utilised by Nyquist-rate and oversampling analog to digital converters (ADCs) to accomplish quantization and perhaps sampling. Thus, comparators have a substantial effect on the speed and accuracy of ADCs. This study…
A high-purity co-axial germanium detector has been calibrated in efficiency to a precision of about 0.15% over a wide energy range. High-precision scans of the detector crystal and gamma-ray source measurements have been compared to…
Parameters describing CPT violation are extracted from a variety of rate asymmetries in the neutral-$D$ system. The precision to which these parameters could be measured in present and planned machines is examined.
This letter proposes a high-efficiency dual-band class-F rectifier for wireless power transmission (WPT). The rectifier comprises a dual-band harmonic termination network, a dual-band matching network, a single Schottky diode, and a dc pass…
The working principle of a electric current transformer is based on electromagnetic induction, mainly composed of a closed iron core and windings. Its primary winding has relatively few turns and is connected in series with the current…
This paper present high precision halfwave rectifier circuit in dual phase output mode by 0.5 micrometer CMOS technology, plus or minus 1.5 V low voltage, it has received input signal and sent output current signal, respond in high…
Multi-scale computational approaches are important for studies of novel, low-dimensional electronic devices since they are able to capture the different length-scales involved in the device operation, and at the same time describe critical…
This paper proposes a nonlinear, adaptive controller to increase the stability margin of a direct-current (DC) small-scale electrical network containing a constant power load, whose value is unknown. Due to their negative incremental…
The electrical {\em dc}-conductivity of disordered, non-interacting electrons is calculated in the asymptotic limit of high lattice dimensions $d\to \infty$. To go beyond the lowest-order contribution in the expansion parameter $1/d$ of the…
The stability and non-linearity of a commercial AH 2700A capacitance bridge were studied beyond its specified capabilities using the Thompson-Lampard Calculable Capacitor (TLCC) at LNE. The TLCC allows for continuous variation of measured…
Dynamics and stability of average current control of DC-DC converters are analyzed by sampled-data modeling. Orbital stability is studied and it is found unrelated to the ripple size of the orbit. Compared with the averaged modeling, the…
Constant-power loads are notoriously known to destabilise power systems, such as DC microgrids, due to their negative incremental impedance. This paper equips distributed generation units with decentralised L1 adaptive controllers at the…
We report on high-accuracy measurements of quantized current, sourced by a tunable-barrier single-electron pump at frequencies $f$ up to $1$ GHz. The measurements were performed with a new picoammeter instrument, traceable to the Josephson…
This paper presents a differential 10-bit 2 MS/s successive approximation register (SAR) analog-to-digital converter (ADC) with a precision-improvement technique. The proposed method breaks the direct tradeoff between the capacitive…
We have built and demonstrated a digital four-arm bridge for the comparison of resistance with capacitance. The digital four-arm bridge mimics the classical quad bridge in the digital domain with three balances: the source balance, the…
We calculate $(\sqrt{-t}/Q)^k $ and $(m/Q)^k$ power corrections with $k\le 4$, where $m$ is the target mass and $t$ is the momentum transfer, to several key observables in Deeply Virtual Compton Scattering (DVCS). We find that the power…
Identifying faulty lines and their accurate location is key for rapidly restoring distribution systems. This will become a greater challenge as the penetration of power electronics increases, and contingencies are seen across larger areas.…
We report on the design and operation of a transport critical-current measurement option for superconductors based on the widely used Physical Property Measurement System from Quantum Design. The system is capable of supplying transport…