Related papers: Spring gravimeter calibration experiment with an i…
The Virgo detector is a kilometer-length interferometer for gravitational wave detection located near Pisa (Italy). During its second science run (VSR2) in 2009, six months of data were accumulated with a sensitivity close to its design. In…
The Virgo detector is a kilometer-scale interferometer for gravitational wave detection located near Pisa (Italy). About 13 months of data were accumulated during four science runs (VSR1, VSR2, VSR3 and VSR4) between May 2007 and September…
Virtual instrument technology has been increasingly used in university physics experiment teaching. An experimental platform is specifically constructed for studying low-frequency vibrations in university physics, which is based on a…
We report on a compact, highly sensitive all-fiber accelerometer suitable for low frequency and low amplitude vibration sensing. The sensing elements in the device are two short segments of strongly coupled asymmetric multicore fiber (MCF)…
In this work we demonstrate a high sensitivity atomic gradiometer capable of operation in earth-field level environments. We apply a light-pulse sequence at four times the Larmor frequency to achieve gradiometer sensitivity <20…
In this contribution, a design of a synthetic calibration genetic circuit to characterize the relative strength of different sensing promoters is proposed and its specifications and performance are analyzed via an effective mathematical…
SPI-ACS/INTEGRAL is one of the most sensitive orbital gamma-ray detectors in energy range above 80 keV. Since 2002 it registered several thousands of gamma-ray bursts, including the bursts associated with LIGO-Virgo gravitational wave…
The problem of imbalance detection in a three-phase power system using a phasor measurement unit (PMU) is considered. A general model for the zero, positive, and negative sequences from a PMU measurement at off-nominal frequencies is…
We study whether the optical properties of a solid glass retroreflector influence the value of the acceleration of gravity $g$ determined by dropping both solid and open retroreflectors in an absolute ballistic gravimeter. The…
Accurate and reliable sensor calibration is critical for fusing LiDAR and inertial measurements in autonomous driving. This paper proposes a novel three-stage extrinsic calibration method between LiDAR and GNSS/INS for autonomous driving.…
This paper proposes and validates an in situ calibration method to calibrate six axis force torque (F/T) sensors once they are mounted on the system. This procedure takes advantage of the knowledge of the model of the robot to generate the…
The elements of the E\"otv\"os matrix are useful for various geodetic applications, such as the interpolation of the elements of the deflection of the vertical, the determination of gravity anomalies and the determination of geoid heights.…
The raw outputs of the detectors within the Advanced Laser Interferometer Gravitational-Wave Observatory need to be calibrated in order to produce the estimate of the dimensionless strain used for astrophysical analyses. The two detectors…
Does gravity influence local measurements? We use a dual-species atom interferometer with $2\,\text{s}$ of free-fall time to measure the relative acceleration between $^{85}$Rb and $^{87}$Rb wave packets in the Earth's gravitational field.…
An analytical expression for the gravitational field of a homogeneous cylinder is derived. The phase of the atom interferometer produced by the gravity field of the set of cylinders has been calculated. The optimal values of the initial…
GRAVITY is the four-beam, near- infrared, AO-assisted, fringe tracking, astrometric and imaging instrument for the Very Large Telescope Interferometer (VLTI). It is requiring the development of one of the most complex instrument software…
This paper develops a risk-aware controller for grid-forming inverters (GFMs) to minimize large frequency oscillations in GFM inverter-dominated power systems. To tackle the high variability from loads/renewables, we incorporate a…
We describe three fundamentally different methods we have applied to calibrate the test mass displacement actuators to search for systematic errors in the calibration of the LIGO gravitational-wave detectors. The actuation frequencies…
A method has been developed for precision measurement of the gravitational frequency shift of communication radio signals between the spacecraft and the ground tracking station based on the maximum likelihood principle, using the Rao-Cramer…
Iteratively Re-weighted Least Squares (IRLS) were used to simulate the $L_p$-norm approximation of the ballistic trajectory in absolute gravimeters. Two iterations of the IRLS delivered sufficient accuracy of the approximation without a…