Related papers: A high-resolution TDC-based board for a fully digi…

A prototype Liquid-argon Trigger Digitizer Board (LTDB), called the LTDB Demonstrator, has been developed to demonstrate the functions of the ATLAS Liquid Argon Calorimeter Phase-I trigger electronics upgrade. Forty Analog-to-Digital…

The NA62 experiment at the CERN SPS reports the first detection of a tagged neutrino candidate based on the data collected in 2022. The candidate consists of a $K^+ \rightarrow \mu^+ \nu_\mu$ decay where the charged particles are…

The GigaTracKer (GTK) is the beam spectrometer of the CERN NA62 experiment. The detector features challenging design specifications, in particular a peak particle flux reaching up to 2.0 MHz/mm$^2$, a single hit time resolution smaller than…

Transverse Deflecting Cavities (TDCs) are generally adopted for electron beam diagnosis. Three sets of S-band and two sets of X-band TDCs are planned at Shenzhen Superconducting Soft X-ray Free Electron Laser (S3FEL) to accurately measure…

Personalized ubiquitous healthcare solutions require energy-efficient wearable platforms that provide an accurate classification of bio-signals while consuming low average power for long-term battery-operated use. Single lead…

Front-end electronics equipped with high-speed digitizers are being used and proposed for future nuclear detectors. Recent literature reveals that deep learning models, especially one-dimensional convolutional neural networks, are promising…

Recent results a future prospects of the NA62 experiment at CERN SPS are presented. The NA62 experiment performed the most precise measurement of the ratio $R_K$ of the $K^+\rightarrow e^\pm\nu$ and K^+\rightarrow \mu^\pm\nu$ decay rates…

.On the basis of requirement of CSNS, we designed a TDC chip with temperature compensation function in this paper, which employed TSMC 180nm process. Using delay unit bufx8 as the major method, delay lines in each level delayed input signal…

A new learning scheme called time divergence-convergence (TDC) is proposed for two-layer dynamic synapse neural networks (DSNN). DSNN is an artificial neural network model, in which the synaptic transmission is modeled by a dynamic process…

We have designed, implemented and tested a time-to-digital converter core in a low-cost Spartan-6 FPGA. Our design exploits the finite propagation speed in carry chains to realize a delay line in which the propagation distance of the…

The goal of the TANGERINE project is to develop the next generation of monolithic silicon pixel detectors using a 65 nm CMOS imaging process, which offers a higher logic density and overall lower power consumption compared to previously…

Finite-difference time-domain methods are increasingly being used to develop, model and analyze the response of materials, including engineered metamaterials that may contain superconductors. Though simple and useful expressions for the…

The HERA-B Outer Tracker is a large detector with 112674 drift chamber channels. It is exposed to a particle flux of up to 2x10^5/cm^2/s thus coping with conditions similar to those expected for the LHC experiments. The front-end readout…

Obtaining digital representations of multivariate continuous-time (CT) signals is a challenge encountered in many signal processing systems. In practice, these signals are often acquired to extract some underlying information, i.e., for a…

Dielectric layers are gradually being down-scaled in different electronic devices like MOSFETs and Magnetic Tunnel Junctions (MTJ) with shrinking device sizes. As a result, time dependent dielectric breakdown (TDDB) has become a major issue…

We have developed a completely new type of general-purpose CCD data acquisition system which enables one to drive any type of CCD using any type of clocking mode. A CCD driver system widely used before consisted of an analog multiplexer…

This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…

There is a growing trend toward using high-level tools for design and implementation of radio astronomy digital signal processing (DSP) systems. Such tools, for example, those from the Collaboration for Astronomy Signal Processing and…

The NA62 experiment at CERN SPS aims to measure the branching ratio of the ultra-rare kaon decay $K^+\to\pi^+\nu\bar{\nu}$ with 10\% precision, collecting $\sim 100$ events, assuming the Standard Model~(SM) branching ratio of $8.4 \times…

This paper presents the design and analysis of a wearable CMOS biosensor with three different designs of energy-resolution scalable time-based resistance to digital converters (RDC), targeted towards either minimizing the energy/conversion…