Related papers: Dynamic Interactions between Oscillating Cantileve…
We investigate the dynamics of a single phonon (oscillator) mode linearly coupled to an electronic few-level system in contact with external particle reservoirs (leads). A stationary electronic current through the system generates…
We propose a device that can operate as a magneto-resistive switch or oscillator. The device is based on a spin-thermo-electronic control of the exchange coupling of two strong ferromagnets through a weakly ferromagnetic spacer. We show…
Casimir forces between conductors at the sub-micron scale cannot be ignored in the design and operation of micro-electromechanical (MEM) devices. However, these forces depend non-trivially on geometry, and existing formulae and…
Recent low-temperature scanning-tunneling microscopy experiments [T. Kumagai et al., Phys. Rev. B 79, 035423 (2009)] observed the vibrationally induced flip motion of a hydroxyl dimer (OD)2 on Cu(110). We propose a model to describe…
We present experimental study of a topological excitation, {\it interface}, in a vertically vibrated layer of granular material. We show that these interfaces, separating regions of granular material oscillation with opposite phases, can be…
Each single domain nano-magnet acts as a magnetic dipole in addition it oscillates its magnetization about the easy axis and rotates coherently depending upon temperature and anisotropy. In an ensemble of nano-magnets, the relaxation time…
The dynamics of a cantilever plate clamped at its trailing edge and placed at a moderate angle ($\alpha \leq 30^{\circ}$) to a uniform flow are investigated experimentally and numerically, and a large experimental data set is provided. The…
We present a combined classical and quantum electrodynamics description of the coupling between two circularly-polarized quantum emitters held above a metal surface supporting surface plasmons. Depending on their position and their natural…
The stochastic dynamics of micron and nanoscale cantilevers immersed in a viscous fluid are quantified. Analytical results are presented for long slender cantilevers driven by Brownian noise. The spectral density of the noise force is not…
The possibility of the mechanical detection of the Casimir friction using the non-contact force microscope is discussed. On a SiO2 tip situated above a graphene-covered SiO2 substrate will act the frictional drag force mediated by a…
The objective of the present study is to explore the connection between the nonlinear normal modes of an undamped and unforced nonlinear system and the isolated resonance curves that may appear in the damped response of the forced system.…
Optomechanical interactions between mechanical oscillators and an electromagnetic field induce controllable modifications in mechanical fluctuation. When multiple mechanical oscillators are coupled to a single electromagnetic mode, these…
We demonstrate a method for manipulating small ensembles of vortices in multiply-connected superconducting structures. A micron-size magnetic particle attached to the tip of a silicon cantilever is used to locally apply magnetic flux…
Multi-scale simulations of nanotube-based nanoelectromechanical systems (NEMS) controlled by a nonuniform electric field are performed by an example of a gigahertz oscillator. Using molecular dynamics simulations, we obtain the friction…
We present a theoretical framework for the dynamic calibration of the higher eigenmode parameters (stiffness and optical lever responsivity) of a cantilever. The method is based on the tip-surface force reconstruction technique and does not…
The mechanical behavior of any semiconductor microstructure is inevitably coupled to light. In the case of micro mechanical resonators (MEMs), carrier generation can affect the quality factor of the resonance through electron-phonon…
Conventional dynamic atomic force microscopy (AFM) can be extended to bimodal and multimodal AFM in which the cantilever is simultaneously excited at two ore more resonance frequencies. Such excitation schemes result in one additional…
The quantitative interatomic force measurements open a new pathway to materials characterization, surface science, and chemistry by elucidating the force between 'two' interacting atoms as a function of their separation. Atomic force…
We present a self-contained study of the dynamics of oscillating nanomenisci anchored on nanometric topographical defects around a cylindrical nanofiber -- radius below 100 nm. Using frequency-modulation atomic force microscopy (FM-AFM), we…
A rigid-flexible manipulator may be assigned tasks in a moving environment where the winds or vibrations affect the position and/or orientation of surface of operation. Consequently, losses of the contact and perhaps degradation of the…