Related papers: Trigger and Data Acquisition for hadron colliders …
The scheme of the data acquisition (DAQ) architecture in High Energy Physics (HEP) experiments consist of data transport from the front-end electronics (FEE) of the online detectors to the readout units (RU), which perform online processing…
This paper presents the design of the LHCb trigger and its performance on data taken at the LHC in 2011. A principal goal of LHCb is to perform flavour physics measurements, and the trigger is designed to distinguish charm and beauty decays…
The central detectors of the ALICE experiment at LHC will produce a data size of up to 75 MByte/event at an event rate <200 Hz resulting in a data rate of \~15 GByte/sec. This exceeds the foreseen mass storage bandwidth of 1.25 GByte/sec by…
The Large Hadron Electron Collider (LHeC) is a proposed upgrade to the LHC, to provide high energy, high luminosity electron-proton collisions to run concurrently with Phase 2 of the LHC. The baseline design of a detector for the LHeC is…
Electron and photon triggers covering transverse energies from 5 GeV to several TeV are essential for the ATLAS experiment to record signals for a wide variety of physics: from Standard Model processes to searches for new phenomena in both…
Many models for physics Beyond the Standard Model predict an increased production rate of tau leptons. Therefore hadronically decaying tau leptons play an important role in searches for new physics at the LHC. By triggering on them, the…
Chapter 8 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in…
The LHCb experiment is designed to perform high-precision measurements of CP violation and search for New Physics using the enormous flux involving beauty and charm quarks produced at the LHC. The operation and the results obtained from the…
The ReadOut System (ROS) is a central part of the data acquisition (DAQ) system of the ATLAS Experiment at the CERN Large Hadron Collider (LHC). The system is responsible for receiving and buffering event data from all detector subsystems…
With the increases in the LHC instantaneous luminosity, maintaining effective triggering and avoiding dead time will become especially challenging. As the sensitivity of many physics studies, depends critically on the ability to maintain…
The planned upgrade of the CMS detector for the High Luminosity LHC allows to find tracks in the silicon tracker for every single LHC collision and use them in the first level (hardware) trigger decision. So far, studies by CMS…
In the search for exotic events involving displaced particles at HL-LHC, the triggering at the level-1 (L1) system will pose a significant challenge. This is particularly relevant in scenarios where low mass long-lived particles (LLPs) are…
The High-Luminosity LHC (HL-LHC) era, set to begin in 2029, will provide the general-purpose experiments with an instantaneous luminosity of up to $\mathcal{L} = 7.5 \times 10^{34}$ cm$^{-2}$ s$^{-1}$ from pp collisions at a centre-of-mass…
The ATLAS hadronic Tile Calorimeter will undergo major upgrades to the on- and off-detector electronics in preparation for the High Luminosity program of the Large Hadron Collider (HL-LHC) in 2026, so that the system can cope with the…
The Phase-I trigger readout electronics upgrade of the ATLAS Liquid Argon calorimeters enhances the physics reach of the experiment during the upcoming operation at increasing Large Hadron Collider luminosities. The new system, installed…
The planned high-luminosity upgrade of the Large Hadron Collider (LHC) at CERN will bring much higher data rates that are far above the capabilities of currently installed software-based data processing systems. Therefore, new methods must…
The CMS Level-1 calorimeter trigger is being upgraded in two stages to maintain performance as the LHC increases pile-up and instantaneous luminosity in its second run. In the first stage, improved algorithms including event-by-event…
As experiments in high energy physics aims to measure increasingly rare processes, the experiments continually strive to increase the expected signal yields. In the case of the High Luminosity upgrade of the LHC, the luminosity is raised by…
Chapter 14 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in…
The CMS experiment has been designed with a 2-level trigger system: the Level 1 Trigger, implemented on custom-designed electronics, and the High Level Trigger (HLT), a streamlined version of the CMS offline reconstruction software running…