Related papers: Direct and alignment-insensitive measurement of ca…
Optical beam deflection is a popular method to measure the deformation of micromechanical devices. As it measures mostly a local slope, its sensitivity depends on the location and size of the optical spot. We present a method to evaluate…
We present a method of broadening the dynamic range of optical interferometric detection of cantilever displacement. The key idea of this system is to use a wavelength-tunable laser source. The wavelength is subject to proportional-integral…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
An interferometric method is implemented in order to accurately assess the thermal fluctuations of a micro-cantilever sensor in liquid environments. The power spectrum density (PSD) of thermal fluctuations together with Sader's model of the…
We describe a method that uses total internal reflection at the water-air interface inside a large, transparent tank, to measure the interface's deflections. Using this configuration, we obtain an optical set-up where the liquid surface…
Micromechanical transducers such as cantilevers for AFM often rely on optical readout methods that require illumination of a specific region of the microstructure. Here we explore and exploit the diffraction effects that have been…
A method to measure the viscosity of liquids at microscales is presented. It uses a thin glass fiber fixed on the tip of the cantilever of an extremely low noise Atomic Force Microscope (AFM), which accurately measures the cantilever…
Measuring transport coefficients at the microscale remains challenging, often relying on indirect methods that require modeling and calibration. This Letter derives universal asymptotic forms for the autocorrelation and relative uncertainty…
In this article, we present a deflection measurement setup for Atomic Force Microscopy (AFM). It is based on a quadrature phase differential interferometer: we measure the optical path difference between a laser beam reflecting above the…
An ongoing challenge in atomic force microscope (AFM) experiments is the quantitative measurement of cantilever motion. The vast majority of AFMs use the optical beam deflection (OBD) method to infer the deflection of the cantilever. The…
The two output signals of quadrature phase interferometers allow to benefit both from the high sensitivity of interferometry (working inside a fringe) and from an extended input range (counting fringes). Their calibration to reach a linear…
We investigate interferometric techniques to estimate the deflection angle of an optical beam and compare them to the direct detection of the beam deflection. We show that quantum metrology methods lead to a unifying treatment for both…
We develop a unified approach for establishing rates of decay for the Fourier transform of a wide class of dynamically defined measures. Among the key features of the method is the systematic use of the $L^2$-flattening theorem obtained in…
We present an innovative technique which allows the simultaneous measurement of the dielectric constant of a material at many frequencies, spanning a four orders of magnitude range chosen between 10 --2 Hz and 10 4 Hz. The sensitivity and…
Mechanical properties of biological samples have been imaged with a \textit{Force Feedback Microscope}. Force, force gradient and dissipation are measured simultaneously and quantitatively, merely knowing the AFM cantilever spring constant.…
A novel direct approach to detect the resin flow front during the Liquid Resin Infusion process under industrial environment is proposed. To detect the resin front accurately and verify the results, which are deduced from indirect…
Euler-Bernoulli beam theory is widely used to successfully predict the linear dynamics of micro- and nano-cantilever beams. However, its capacity to characterize the nonlinear dynamics of these devices has not yet been rigorously assessed,…
We obtain fractal Lipschitz-Killing curvature-direction measures for a large class of self-similar sets F in R^d. Such measures jointly describe the distribution of normal vectors and localize curvature by analogues of the higher order mean…
We have demonstrated several inexpensive methods which can be used to measure the deflection angles of prisms with microradian precision. The methods are self-referenced, using various reversals to achieve absolute measurements without the…