Related papers: A real-time beam current density meter
Measurement of the current-voltage characteristics of point contacts makes it possible to study the properties of individual crystallites in a superconducting ceramic. The critical current density in the superconducting regions of the…
This contribution presents a novel bunch current measurement system based on an ultra-fast photodetector and a high-speed digitizer at Hefei Light Source II (HLS II). In order to achieve bunch-by-bunch resolution, the sampling rate of the…
We have used a commercial RF ion-source to extract a beam of metastable neon atoms. The source was easily incorporated into our existing system and was operative within a day of installation. The metastable velocity distribution, flux,…
The local work function of a surface determines the spatial decay of the charge density at the Fermi level normal to the surface. Here, we present a method that enables simultaneous measurements of local work function and tip-sample forces.…
We have commenced experiments with intense short pulses of ion beams on the Neutralized Drift Compression Experiment-II at Lawrence Berkeley National Laboratory, by generating beam spots size with radius r < 1 mm within 2 ns FWHM and…
Accurate knowledge of absorption coefficient of a sample is a prerequisite for measuring the third order optical nonlinearity of materials, which could become a serious limitation for unknown samples. We introduce a new method, which…
Standard dosimetry protocols exist for highly penetrating photon and particle beams used in the clinic and in research. However, these protocols cannot be directly applied to shallow penetration MeV-range ion beams. The Radiological…
In this work, Rayleigh microwave scattering was utilized to measure the electron number density produced by nanosecond high voltage breakdown in air between two electrodes in a pin-to-pin configuration (peak voltage 26 kV and pulse duration…
We demonstrate a compact ion beam device capable of accelerating H$^+$ and D$^+$ ions up to 75keV energy, on to a solid target, with sufficient beam current to study fusion reactions. The ion beam system uses a microwave driven plasma…
The electron beam dynamics in a nonmagnetized high-current vacuum diode is analyzed for different cathode-anode gap geometries. The conditions enabling to achieve the minimal {initial} momentum spread in the electron beam are found out. A…
Scanning Electron Microscopy (SEM) experiments provide detailed insights into material microstructures, enabling high-resolution imaging as well as crystallographic analysis through advanced techniques like Electron Backscatter Diffraction…
Muon beam monitoring is indispensable for indirectly monitoring accelerator-produced neutrino beams in real time. Though Si photodiodes and ionization chambers have been successfully used as muon monitors at the T2K experiment, sensors that…
The extremely low dark current of silicon carbide (SiC) detectors, even after high-fluence irradiation, was utilized to develop a beam monitoring system for a wide range of particle rates, i.e., from the kHz to the GHz regime. The system is…
The determination of beam parameters is essential for the operation and development of any accelerator facility. The working principle of frequently used beam instruments for electron and proton beams is discussed. The article comprises of…
High critical current density Jc is generally the most important property of any superconductor used for applications. The critical current Ic is most frequently measured by transport 4 probe V-I techniques and the measured Ic is then…
We present a method to measure the spectral density of in-band optical transmission impairments without coherent electrical reception and digital signal processing at the receiver. We determine the method's accuracy by numerical simulations…
The extreme sensitivity of 2D materials to defects and nanostructure requires precise imaging techniques to verify presence of desirable and absence of undesirable features in the atomic geometry. Helium-ion beams have emerged as a…
A novel method for the direct measurement of the degree of polarization is described. It is one of the first practical implementations of a coherent quantum measurement, the projection on the singlet state. Our first results demonstrate the…
One drawback of conventional quantum state tomography is that it does not readily provide access to single density matrix elements, since it requires a global reconstruction. Here we experimentally demonstrate a scheme that can be used to…
A Bayesian model to infer edge electron density profiles is developed for the JET lithium beam emission spectroscopy system, measuring Li I line radiation using 26 channels with ~1 cm spatial resolution and 10~20 ms temporal resolution. The…