Related papers: A direct time measurements technique for the two-d…
A CdTe double-sided strip detector (CdTe-DSD) is an ideal device for imaging and spectroscopic measure- ments in the hard X-ray range above 10 keV. Recent development enables us to realize an imager with a detection area of ~10 cm${^2}$. An…
A new method for directional fast neutron detection is proposed based on a neutron time projection chamber (TPC) and position-sensitive plastic scintillation detectors. The detection system can efficiently locate the approximate location of…
One contribution to the time resolution of a scintillation detector is the signal time spread due to path length variations of the detected photons from a point source. In an experimental study a rectangular scintillator was excited by…
This paper presents an attractive method towards sensing and quantifying the concentration of dielectric particles suspended in a highly conductive medium. Fast electrical impedance spectroscopy (EIS) measurements were performed, based on…
We develop a formalism to describe electron ejections from graphene-like targets by dark matter (DM) scattering for general forms of scalar and spin 1/2 DM-electron interactions and compare their applicability and accuracy within the…
The Dynamic Time Warping (DTW) distance is a popular measure of similarity for a variety of sequence data. For comparing polygonal curves $\pi, \sigma$ in $\mathbb{R}^d$, it provides a robust, outlier-insensitive alternative to the…
The Dark Matter Time Projection Chamber collaboration recently reported a dark matter limit obtained with a 10 liter time projection chamber filled with CF4 gas. The 10 liter detector was capable of 2D tracking (perpendicular to the drift…
The article presents results of studying the operating mode of thin-walled drift tubes (straws) at flushing it with a high-pressure gas mixture, which allowed obtaining extremely high spatial resolution for straw detectors. The results of…
By employing the equivalent of a knife-edge measurement for matter-waves, we are able to characterize ultra-low momentum widths. We measure a momentum width corresponding to an effective temperature of 0.9 $\pm$ 0.2 nK, limited only by our…
In this work, non-destructive virtual diagnostics are applied to retrieve the electron beam time of arrival and energy in a relativistic ultrafast electron diffraction (UED) beamline using independently-measured machine parameters. This…
A system of two microchannel-plate detectors has been successfully implemented for tracking projectile-fragmentation beams. The detectors provide interaction positions, angles, and arrival times of ions at the reaction target. The current…
A simple self-referenced non destructive method is proposed for measuring the cutoff wavelength of microstructured optical fibers (MOFs). It is based on the analysis of the time dependent optical power transmitted through a bow-tie slit…
The finite-difference time-domain (FDTD) method is applied for modelling of wire media as artificial dielectrics. Both frequency dispersion and spatial dispersion effects in wire media are taken into account using the auxiliary differential…
We present a novel electrical technique to measure the tension of wires in multi-wire drift chambers. We create alternating electric fields by biasing adjacent wires on both sides of a test wire with a superposition of positive and negative…
Two-dimensional (2D) photonic crystals offer strong control over the propagation of light through their bands. Theoretical methods for computing the band structure in 2D are well-established and fast because 2D photonic crystals are…
We present a systematic accuracy assessment of the thin-element approximation (TEA), the beam propagation method (BPM), and the wave propagation method (WPM) for binary diffractive gratings, using the rigorous Fourier modal method (FMM) as…
In the near future there will be the request for very large liquid Xenon (LXe) detectors for Dark Matter (DM) searches in the 50-ton range. To avoid an impractically long, single drift space of a dual-phase detector, it seems beneficial to…
The construction of low mass vertex detectors with a high level of system integration is of great interest for next generation collider experiments. Radiation length images with a sufficient spatial resolution can be used to measure and…
We propose a novel direct sampling method (DSM) for the effective and stable inversion of the Radon transform. The DSM is based on a generalization of the important almost orthogonality property in classical DSMs to fractional order Sobolev…
A system based on commercially available items, such as a laser diode, emitting in the visible range $\sim 400$ nm,and multimode fiber patches, fused fiber splitters and optical switches may be assembled,for time calibration of…