Related papers: Subtraction of test mass angular noise in the LISA…

The multiple Doppler readouts available on the Laser Interferometer Space Antenna (LISA) permit simultaneous formation of several interferometric observables. All these observables are independent of laser frequency fluctuations and have…

The Laser Interferometer Space Antenna (LISA) will explore the source-rich milli-Hertz band of the gravitational wave spectrum. In contrast to ground based detectors, where typical signals are short-lived and discrete, LISA signals are…

TianQin is a proposed space-based mission for gravitational wave detection, employing a constellation of three drag-free satellites in high Earth orbits to form a laser interferometric observatory. A critical technical challenge is…

A four mass torsion pendulum facility for testing of the LISA GRS is under development in Trento. With a LISA-like test mass suspended off-axis with respect to the pendulum fiber, the facility allows for a direct measurement of surface…

Interspacecraft ranging is crucial for the suppression of laser frequency noise via time-delay interferometry (TDI). So far, the effects of on-board delays and ambiguities on the LISA ranging observables were neglected in LISA modelling and…

The Laser Interferometer Space Antenna (LISA) is being designed to detect and study in detail gravitational waves from sources throughout the Universe such as massive black hole binaries. The conceptual formulation of the LISA space-borne…

In this paper, we report the development of an intensity modulated fiber optic sensor for angular displacement measurement. This sensor was designed to present high sensitivity, linear response, wide bandwidth and, furthermore, to be simple…

In this paper we discuss two main problems associated with the analysis of the data from LISA Pathfinder (LPF): i) Excess noise detection and ii) Noise parameter identification. The mission is focused on the low frequency region ([0.1; 10]…

Each spacecraft in the Laser Interferometer Space Antenna houses a proof mass which follows a geodesic through spacetime. Disturbances which change the proof mass position, momentum, and/or acceleration will appear in the LISA data stream…

Tilt-to-length coupling was the limiting noise source in LISA Pathfinder between 20 and 200 mHz before subtraction in post-processing. To prevent the adding of sensing noise to the data by the subtraction process, the success of this…

The LISA Pathfinder mission will demonstrate the technology of drag-free test masses for use as inertial references in future space-based gravitational wave detectors. To accomplish this, the Pathfinder spacecraft will perform drag-free…

We report on three numerical experiments on the implementation of Time-Delay Interferometry (TDI) for LISA, performed with Synthetic LISA, a C++/Python package that we developed to simulate the LISA science process at the level of…

We propose an experiment to extract ponderomotive squeezing from an interferometer with high circulating power and low mass mirrors. In this interferometer, optical resonances of the arm cavities are detuned from the laser frequency,…

Interferometric gravitational-wave detectors like LIGO need to be able to measure changes in their arm lengths of order $10^{-18}~$m or smaller. This requires very high laser power in order to raise the signal above shot noise. One…

Laser frequency stabilization is notably one of the major challenges on the way to a space-borne gravitational wave observatory. The proposed Laser Interferometer Space Antenna (LISA) is presently under development in an ESA, NASA…

We report a laser noise reduction method by locking it to an actively stabilized fiber-based Mach Zehnder interferometer with 10 km optical fiber to achieve large arm imbalance. An acousto optic modulator is used for interferometer…

The Laser Interferometer Space Antenna (LISA) is a planned space-based observatory designed to detect gravitational waves (GWs) within the millihertz frequency range. LISA is anticipated to observe the inspiral of compact objects into black…

We report here the characterization (temperature coefficients and noise level) of selected voltage references in the frequency range from 10^(-5) to 10 Hz. The goal of this work is to update previous studies, with a characterization at…

One of the atom interferometer gravitational wave missions proposed by Dimopoulos et al.1 in 2008 was called AGIS-Sat. 2. It had a suggested gravitational wave sensitivity set by the atom state detection shot noise level that started at 1…

The LIGO experiment aims to detect and study gravitational waves using ground based laser interferometry. A critical factor to the performance of the interferometers, and a major consideration in the design of possible future upgrades, is…