Related papers: Subtraction of test mass angular noise in the LISA…
The basic constituent of interferometric gravitational wave detectors -- the test mass to test mass interferometric link -- behaves as a differential dynamometer measuring effective differential forces, comprising an integrated measure of…
Space-based gravitational wave detectors, such as the Laser Interferometer Space Antenna (LISA), use picometer-precision laser interferometry to detect gravitational waves at frequencies from 1 Hz down to below 0.1 mHz. Laser…
The orbital motion of the Laser Interferometer Space Antenna (LISA) introduces modulations into the observed gravitational wave signal. These modulations can be used to determine the location and orientation of a gravitational wave source.…
High-resolution temperature measurements are required in the LTP, i.e., 10 uK/sqrt(Hz) from 1 mHz to 30 mHz. This has been already accomplished with thermistors and a suitable low noise electronics. However, the frequency range of interest…
Tilt-to-length (TTL) noise, caused by angular jitter and misalignment, is a major noise source in the inter-satellite interferometer for gravitational wave detection. However, the required level of axis alignment of the optical components…
For the LISA mission, Tilt-To-Length (TTL) coupling is expected to be one of the dominant instrumental noise contributions after laser frequency noise is suppressed based, on assumptions on the size of the coupling and angular jitter…
The analysis of the noise sources perturbing a test mass (TM) geodesic motion is the main scientific objective of the LISA Technology Package experiment (LTP) on board of the LISA Pathfinder space mission. Information on force noise acting…
We previously showed how the measurements of some eighteen time series of relative frequency or phase shifts could be combined (1) to cancel the phase noise of the lasers, (2) to cancel the Doppler fluctuations due to non-inertial motions…
In order to attain the requisite sensitivity for LISA - a joint space mission of the ESA and NASA- the laser frequency noise must be suppressed below the secondary noises such as the optical path noise, acceleration noise etc. By combining…
LISA is the proposed ESA-NASA gravitational wave detector in the 0.1 mHz - 0.1 Hz band. LISA Pathfinder is the down-scaled version of a single LISA arm. The arm -- named Doppler link -- can be treated as a differential accelerometer,…
The proposed Laser Interferometer Space Antenna (LISA) mission is tasked with the detection and characterization of gravitational waves from various sources in the universe. This endeavor is challenged by transient displacement and…
Noise measurements have been carried out in the LISA bandwidth (0.1 mHz to 100 mHz) to characterize an all-optical atomic magnetometer based on nonlinear magneto-optical rotation. This was done in order to assess if the technology can be…
This article reviews the present status of the technology and instrumentation for the joint ESA/NASA gravitational wave detector LISA. It briefly describes the measurement principle and the mission architecture including the resulting…
The Laser Interferometer Space Antenna (LISA) aims to observe gravitational waves in the mHz regime over its 10-year mission time. LISA will operate laser interferometers between three spacecrafts. Each spacecraft will utilize independent…
Laser frequency stabilization is a critical part of the interferometry measurement system of space-based gravitational wave observatories such as the Laser Interferometer Space Antenna (LISA). Arm locking as a proposed frequency…
The observation of massive black hole binary systems is one of the main science objectives of the Laser Interferometer Space Antenna (LISA). The instrument's design requirements have recently been revised: they set a requirement at…
We describe three fundamentally different methods we have applied to calibrate the test mass displacement actuators to search for systematic errors in the calibration of the LIGO gravitational-wave detectors. The actuation frequencies…
In the context of the Laser Interferometer Space Antenna (LISA), the laser subsystems exhibit frequency fluctuations that introduce significant levels of noise into the measurements, surpassing the gravitational wave signal by several…
In a space based gravitational wave antenna like LISA, involving long light paths linking distant emitter/receiver spacecrafts, signal detection amounts to measuring the light-distance variationsthrough a phase change at the receiver. This…
We have developed a torsion pendulum facility for LISA gravitational reference sensor ground testing that allows us to put significant upper limits on residual stray forces exerted by LISA-like position sensors on a representative test mass…