Related papers: Optical layout for a 10m Fabry-P\'erot Michelson i…
In this work, we report optomechanical coupling, resolved sidebands and phonon lasing in a solid-core microbottle resonator fabricated on a single mode optical fiber. Mechanical modes with quality factors (Q_m) as high as 1.57*10^4 and…
In this article we describe the characteristics of a large integrated linear optical device containing Mach-Zehnder interferometers and describe its potential use as a physically unclonable function. We propose that any tunable…
We demonstrate the applicability of the EPR entanglement squeezing scheme for enhancing the shot-noise-limited sensitivity of a detuned dual-recycled Michelson interferometers. In particular, this scheme is applied to the GEO\,600…
We analyze a cavity optomechanical setup, in which position of an oscillator modulates optical loss. We show that in such setup quantum limited position measurements can be performed if the external cavity coupling rate matches the optical…
We present a modular rack-mounted laser system for the cooling and manipulation of neutral rubidium atoms which has been developed for a portable gravimeter based on atom interferometry that will be capable of performing high precision…
The response of Michelson interferometers to weak plane gravitational waves is computed at one order of accuracy beyond the eikonal equation. The modulation of the electromagnetic field amplitude and polarisation are taken into account by…
Thermal noise in optical cavities imposes a severe limitation in the stability of the most advanced frequency standards at a level of a few 10^(-16) (s/t)^(1/2) for long averaging times t. In this paper we describe two schemes for reducing…
We report on the optical response of a suspended-mass detuned resonant sideband extraction (RSE) interferometer with power recycling. The purpose of the detuned RSE configuration is to manipulate and optimize the optical response of the…
Contactless characterization of mechanical resonances using Fabry-Perot interferometry is a powerful tool to study the mechanical and dynamical properties of atomically thin membranes. However, amplitude calibration is often not performed,…
Nonlinear quantum metrology schemes can lead to faster than Heisenberg limited scalings for the measurement uncertainty. We study a Michelson interferometer embedded in a Kerr medium [Luis and Rivas, Phys. Rev. A 92, 022104 (2015)] that…
For gravitational-wave interferometric detectors, there is a tradeoff between the detector bandwidth and peak sensitivity when focusing on the shot noise level. This has to do with the frequency-dependent propagation phase lag (positive…
Optical cavities find diverse uses in lasers, frequency combs, optomechanics, and optical signal processors. Complete reconfigurability of the resonant frequency as well as the loss enables development of generic field programmable cavities…
The sensitivity of current and planned gravitational wave interferometric detectors is limited, in the most critical frequency region around 100 Hz, by a combination of quantum noise and thermal noise. The latter is dominated by Brownian…
Einstein Telescope (ET) is expected to achieve sensitivity improvements exceeding an order of magnitude compared to current gravitational-wave detectors. The rigorous characterization in optical birefringence of materials and coatings has…
This Technical Design Report presents AION-10, a 10-meter atom interferometer to be located at Oxford University using ultracold strontium atoms to make precision measurements of fundamental physics. AION-10 serves as both a prototype for…
We have developed a system for tapered fiber measurements of optomechanical resonators inside a dilution refrigerator, which is compatible with both on- and off-chip devices. Our apparatus features full three-dimensional control of the…
Interferometric detection of mirror displacements is intrinsically limited by laser shot noise. In practice, however, it is often limited by thermal noise. Here we report on an experiment performed at the liquid helium temperature to…
Sensitivity of gravitational-wave detectors is limited in the high-frequency band by quantum shot noise and eventually limited by the optical loss in signal recycling cavity. This limit is the main obstacle on the way to detect…
This study presents a detailed investigation of the modulational stability of interfacial wave packets in a two-layer inviscid incompressible fluid with finite layer thicknesses and interfacial surface tension. The stability analysis is…
Interferometric gravitational-wave detectors like LIGO need to be able to measure changes in their arm lengths of order $10^{-18}~$m or smaller. This requires very high laser power in order to raise the signal above shot noise. One…