Related papers: Laser frequency offset locking scheme for high-fie…
A low complexity frequency offset estimation algorithm based on all-phase FFT for M-QAM is proposed. Compared with two-stage algorithms such as FFT+CZT and FFT+ZoomFFT, our algorithm can lower computational complexity by 73% and 30%…
Currently laser cooling schemes are fundamentally based on the weak coupling regime. This requirement sets the trap frequency as an upper bound to the cooling rate. In this work we present a numerical study that shows the feasibility of…
We report on a device to electronically stabilize the optical injection lock of a semiconductor diode laser. Our technique uses as discriminator the peak height of the laser's transmission signal on a scanning Fabry-Perot cavity and feeds…
Demand for low-noise, continuous-wave, frequency-tunable lasers based on semiconductor integrated photonics has been advancing in support of numerous applications. In particular, an important goal is to achieve narrow spectral linewidth,…
In cold atomic systems, fast and high-resolution microscopy of individual atoms is crucial, since it can provide direct information on the dynamics and correlations of the system. Here, we demonstrate nanosecond-scale two-dimensional…
External-cavity diode lasers are ubiquitous in atomic physics and a wide variety of other scientific disciplines, due to their excellent affordability, coherence length and versatility. However, for higher power applications, the…
This article theoretically proposes a new dual interferometer technique to accurately calibrate two laser frequencies simultaneously using four-wave mixing in an alkali metal vapor cell. The two frequency-calibrated lasers are mixed to…
Optoelectronic down-conversion of a THz optical beatnote to a RF intermediate frequency is performed with a standard Mach-Zehnder modulator followed by a zero dispersion-slope fiber. The two interleaved optical spectra obtained by four-wave…
Atomic clocks play a crucial role in timekeeping, communications, and navigation systems. Recent efforts enabled by heterogeneous MEMS integration have led to the commercial introduction of Chip-Scale Atomic Clocks (CSAC) with a volume of…
A major limitation of transient optical spectroscopy is that relatively high laser fluences are required to enable broadband, multichannel detection with acceptable signal-to-noise levels. Under typical experimental conditions, many…
A spectrometer for ultra high-resolution spectroscopy of molecular iodine at wave length 501.7 nm, near the dissociation limit is described. Line shapes about 30 kHz wide (HWHM) were obtained using saturation spectroscopy in a pumped cell.…
The theoretically predicted correlation of laser phase fluctuations in Lambda-type interaction schemes is experimentally demonstrated. We show, that the mechanism of correlation in a Lambda scheme is restricted to high frequency noise…
The Pound-Drever-Hall (PDH) technique is widely used to stabilize the frequency of lasers. Here we report on a routinely underestimated source of error in PDH offset-locking: a shift in the lock point due to the unintended interaction…
We present a Dual Isotope Magneto Optical Trap produced using a single diode laser. We generate all the optical frequencies needed for trapping both species using a fiber intensity modulator. All the optical frequencies are amplified…
Atomic sensors employing cold-atom technology enable unprecedented accuracy and resolution for next generation atomic clocks, magnetometers, gravimeters, and gyroscopes. To date, however, the size and complexity of cold atom systems have…
Optical lattices serve as fundamental building blocks for atomic quantum technology. However, the scale and resolution of these lattices are diffraction-limited to the light wavelength. In conventional lattices, achieving tight confinement…
We have quantified a short term instability budget for an optical frequency standard based on cold, freely expanding calcium atoms. Such systems are the subject of renewed interest due to their high frequency stability and relative…
Frequency stabilisation of lasers to optical reference cavities is an established method to achieve state-of-the-art stability. The strengths of this method are the high discriminator coefficient of optical cavities, and the low-noise…
We have implemented a simple and cost-effective digital system for long-term frequency stabilisation and locking to an arbitrary wavelength of the single-frequency ring CW Ti:Sapphire laser. This system is built around two confocal…
We developed an ultra-compact high-resolution imaging system for cold atoms. Its only in-vacuum element is a multimode optical fiber with a diameter of $230\,\mu$m, which simultaneously collects light and guides it out of the vacuum…